There's also an adjustment that you can make manually to move the power up or down from what the meter is reflecting on the K3, have you tried that too? > Date: Fri, 29 Oct 2010 17:00:21 -0400 > From: [email protected] > To: [email protected] > Subject: [Elecraft] K3: LPA power level accuracy? > > Hello fellow Elecrafters, > > Quick question - I've noticed that when using the LPA, output power is > always slightly off compared to the reading given off by two fairly accurate > meters. For example, a constant carrier output of 5 watts always reads > about a half-watt less on the external meters. The output power from the > KPA3 however has always been on the dot - 80 watts drive reads 80 on the > meter, 100 watts output reads 100W on the meter, etc. etc. > > I'm not really concerned, but was wondering if this was typical? I've > calibrated several times in the past using the K3 utility, but the results > are usually the same. > > -- > 73 de James K2QI > President UNARC/4U1UN > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
