See p 45 of the manual "Firmware Upgrades". Jim K4JAF ----- Original Message ----- From: "Jens Petersen" <[email protected]> To: "Elecraft Reflector" <[email protected]> Sent: Thursday, September 02, 2010 11:41 AM Subject: [Elecraft] [K3] Firmware load gone bad.
> Hi. > > While attemting to load newest firmware the upload never started and > display says "MCU LD" and TX is blinking. > > Got newest K3 utility but there is no connection to K3. > > K3 can now do nothing but blink the TX LED and display says MCU LD. > > How do I reset K3 so I can try again? > > K3# 3238 > P3# 310 > -- > OV1A Jens > > Remember, If you're not in bed by 22:30..... go home! > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
