Check the crimp connections on the spades that connect to the circuit breaker...
~Brett (N7MG) On Sat, 2010-08-21 at 20:55 +0000, Paul Ormandy ZL4PW wrote: > Hi all, > > Yesterday, the K3 threw up the "Err 12V" error and bypassed the KPA3 > module. The circuit breaker didn't pop and I was able to power off and > increase the power back up. > > This was happening on PSK with 50W and RTTY with 100W. > > I have yet to try digi modes in anger again today without first getting > some feedback. I had close to zero AGC/compression when this occurred. > > Any suggestions will be most welcome. > > Regards, > > Paul > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
