I had the same issue (there really should be a note there indicating that
you need to set the transformer back a hair to allow clearance for this later
step!).
I scooted the resistors forward a bit to solve my clearance problem. It's
always a good idea to leave a LITTLE air under power resistors, to help
them dissipate some heat. Mine stood off the board about 1/8" which was
just enough to allow
me to scoot them forward a tad, to get this cap in.
John K5MO
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.10.2 - Release Date: 4/21/2005
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
