Hello Fellow K2 Owners:
I recently finished my K2 (4661) and it works great. My kit came with
the 10uH L31, which I did install, however Elecraft sent me the 12uH
L31 to swap in order to bring the PLL Reference Oscillator range up
from 9.4kHz to something closer to the 9.8kHz range. As we know, the
official advice from Elecraft is that a range down to 8.8kHz is
acceptable. So I assume that Elecraft sent the 12uH part so that I
could make the swap if I felt better doing so. Or perhaps it's just
that opinions on what is an acceptable range vary.
So my question is this: what performance gain would I get by using the
12uH part instead of the 10uH part that is currently installed? Yes, I
could just make the swap and see for myself, but too often I've found
that the "If it ain't broke, don't fix it" adage to be a good one (at
least for this less technically inclined ham). Maybe when the radio has
a few more miles on it, I'll go ahead and make the change to L31 to see
what happens, but for now I'm tempted to just keep things as they are
unless there is a compelling reason to make the change.
Mike NR7F
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
