A common cause of that behavior is a solder bridge on the thermistor circuit board. Check it carefully at least 3 times.
73, Don W3FPR > -----Original Message----- > > VCO Alignment (p61) > VFO set at 4000 kHz > @R30 left side = 0.018 vdc > L30 verified as a 4.7 uH "T005Z" > C72 verified as a 270 pF "271" > > Rewound T5 > verified primary = 16 turns > verified secondary = 4 > > Adjusting L30 has no effect on R30 voltage reading. > > **************************************************************** > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
