Hello! I ran the K2/100 during the ARRL Contest for 13 hours full power sometimes during a whole hour in the RUN mode (3 - 4 QSO's per minute) and made 600 contacts without any problem. Today I made a few more CW contacts and the K2 switched totally off for some unknown reason. Seemed like the DC power was tuned off by a safety device. Switching the K2 on after a while and all was OK again.
Sometimes I note "Hi Cur" (set to 3.5 A) or a "Hi refl" (SWR below 1.4) for a very short time on the display - but I got used to this strange behaviour in the past...? Any hints on this one?? 73 Gert, OE3ZK K2 # 2200 (with all latest mods in it). _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
