Don't want to drag this out, but I am with you Ron. I find that the "warts" give the K2/100 an "unfinished" look, stands out like a sore thumb against most other gear in the shack. I hope that any new products that might come from Elecraft will NOT have "warts".
73, Geoff GM4ESD ----- Original Message ----- From: "ZL1TW" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Monday, February 07, 2005 3:36 AM Subject: [Elecraft] Re: KPA100 middle screw alteration > > When I replaced the screws on my K2/100, I drilled a hole right through > the heat-sink rail on the KPA100 at the middle screw mounting, and tapped > it for 4-40 and installed a bit longer screws. > No messing about with inserts, quick and easy, and is not noticeable. Just > need the appropriate tap. > Cheers......Ron ZL1TW > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
