hello wonder if any one can advise have just come up to page 61 elecraft manual vco alignment sarted off ok was able to get 6 volt on 80 mtrs at 4000 then the metre shot up to 8 volt moving the vfo dial slightly restores to the set volts moving the vfo dial again slightly it shoots up to 8 volts same on all bands when the metre is at 8 volts there is no adjustment posible at l 30 same on all bands all caps are correct value been over all relevant soldering again not sure if it is posible to test varicap diodes dont want to start removing them dont have replacements if the volts is set to the correct value and left without moving any thingit stays at that value thanks all tom g0lne _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
