What I do is to set the power for 5watts in qrpmode and adjust PC to the
point where output just drop a little bit.
I think this will be almost the same as set power for 10 watts and adjust
pcoutput for 5watts.
Somehow I have never liked the second method because I like to limit my TX
the hard and secure way.
Some also advice to set tone for psk31 to a frequency so high that harmonics
is outside the passband the ksb2 is capable to send in.
If you have basic KSB2 you could set tone to 1200-1300hz.
Harmonics will then be attenuated.
But I have tried to send 1000hz tone with 5watt setting and pcoutput just at
droppoint.
Nothing sounds wrong on other rx in schack. No harmonics.
73 de Tom LA1PHA
----- Original Message -----
From: "Dan Barker" <[EMAIL PROTECTED]>
To: "Elecraft" <[email protected]>
Sent: Saturday, November 13, 2004 9:52 PM
Subject: [Elecraft] PSK31 question
Question about transmitter drive setup.
I'm about to go on the air with the K2 Power knob full clockwise, and the
soundcard drive (Digipan) set for about 1A draw on key down. Is that
right?
Dan / WG4S / K2 #2456 with KPSK2, er, ah KSB2
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
