Yes. I also get less change (as compared to 30m and 40m) when changing RF gain. I have also noticed (as predicted by Elecraft) that the KX1 is sensitive to your choice of headphones.
-----Original Message----- From: Michael Babineau [mailto:[EMAIL PROTECTED] Sent: Thursday, August 19, 2004 8:51 AM To: [email protected] Subject: [Elecraft] KX1 RX Sensitivity on 20M vs 30M, 40M Have others noticed less RX sensitivity on the KX1 on 20M as compared to 40M and 30M? I recall that this was noted in the QRP Quarterly review of the KX1 a little while back and I have also noticed this on my own rig, so I am guessing that this is normal. Sensitivity is still sufficient on 20M but requires cranking the AF Gain a little higher on 20M than the other bands to get a similar signal volume. Michael VE3WMB P.S. This came to my attention again last night as I had to realign the Rig after finally getting around to installing the 30M module. BTW For such a little board the KXB30 was a real pain in the you-know-where to install! P.P.S I also put the Elecraft supplied sticker over the opening on the KXPD1 and it now looks much better ! _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
