Le jeudi 22 novembre 2007 à 09:13 +0100, SZABO Zsolt a écrit : > Hi, > > I've got the following problem (Ekiga 2.0.9 for etch): > > I CAN use ekiga through a vpn tunnel (of my office), when I setup the vpn > as the default gateway and enable the ports 5000:5100 in the FORWARD chain > at the firewall of the office. To more precisely say, the echo test on > [EMAIL PROTECTED] seems to work (I can hear the welcome message and later my > voice). > > However, I would like to setup ekiga without this vpn hack. When I forward > the port 5000:5100 on the SpeedTouch home gw to my linux box ekiga CAN > register either setting the NAT mode to STUN or IP translation. > I have also succeeded in connecting to [EMAIL PROTECTED] but I CANNOT hear > anything! I have checked my registration by logging in ekiga.net, and I > see: [EMAIL PROTECTED]:4053 > > That was a bit strange, thus I set back the default gw to the vpn, and > rerun ekiga and the echo test (with success) and checked the registration > at ekiga.net again: [EMAIL PROTECTED]:5061 ... > > So, setting the default gw to my home gateway and rerunning ekiga a couple > of times and testing the registration showed every time different port > number out of the range 5000:5100. Thus I have enabled the port forwarding > on SpeedTouch home gw for ports 4000:5900, and checked the registration > again: the port was 5902! (Earlier I had also tried to forward all port on > the home gw (1:65535) but as fas as I remember that did not work at > all...) >
I suppose your router supports SIP and rewrites the packets. You can try two things : 1) use no IP translation and no stun 2) disable SIP support on your router I am nearly sure it is the problem, the 4053 does not look correct. -- _ Damien Sandras (o- //\ Ekiga Softphone : http://www.ekiga.org/ v_/_ NOVACOM : http://www.novacom.be/ FOSDEM : http://www.fosdem.org/ SIP Phone : sip:[EMAIL PROTECTED] _______________________________________________ ekiga-list mailing list [email protected] http://mail.gnome.org/mailman/listinfo/ekiga-list
