Setup the STP state for all VLANs installed on the port. This is also
avoiding the error situation when the DEFAULT_VLAN_ID is not installed
on the port (thus the firmware complains that it cannot setup the
required STP state).
Signed-off-by: Ioana Ciornei <ioana.cior...@nxp.com>
---
drivers/staging/fsl-dpaa2/ethsw/ethsw.c | 21 +++++++++++++--------
1 file changed, 13 insertions(+), 8 deletions(-)
diff --git a/drivers/staging/fsl-dpaa2/ethsw/ethsw.c
b/drivers/staging/fsl-dpaa2/ethsw/ethsw.c
index 530e4105375c..83e6bd4a803b 100644
--- a/drivers/staging/fsl-dpaa2/ethsw/ethsw.c
+++ b/drivers/staging/fsl-dpaa2/ethsw/ethsw.c
@@ -183,21 +183,26 @@ static int ethsw_port_set_flood(struct ethsw_port_priv
*port_priv, bool enable)
static int ethsw_port_set_stp_state(struct ethsw_port_priv *port_priv, u8
state)
{
struct dpsw_stp_cfg stp_cfg = {
- .vlan_id = DEFAULT_VLAN_ID,
.state = state,
};
int err;
+ u16 vid;
if (!netif_running(port_priv->netdev) || state == port_priv->stp_state)
return 0; /* Nothing to do */
- err = dpsw_if_set_stp(port_priv->ethsw_data->mc_io, 0,
- port_priv->ethsw_data->dpsw_handle,
- port_priv->idx, &stp_cfg);
- if (err) {
- netdev_err(port_priv->netdev,
- "dpsw_if_set_stp err %d\n", err);
- return err;
+ for (vid = 0; vid <= VLAN_VID_MASK; vid++) {
+ if (port_priv->vlans[vid] & ETHSW_VLAN_MEMBER) {
+ stp_cfg.vlan_id = vid;
+ err = dpsw_if_set_stp(port_priv->ethsw_data->mc_io, 0,
+
port_priv->ethsw_data->dpsw_handle,
+ port_priv->idx, &stp_cfg);
+ if (err) {
+ netdev_err(port_priv->netdev,
+ "dpsw_if_set_stp err %d\n", err);
+ return err;
+ }
+ }
}
port_priv->stp_state = state;
--
2.25.1
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
