On Tue, Oct 29, 2019 at 09:10:07AM +0100, Greg KH wrote:
> On Tue, Oct 29, 2019 at 12:59:25AM +0200, Samuil Ivanov wrote:
> > >From the TODO:
> > - apex_get_status() should actually check status
> >
> > The function now checkes the status of the driver
> >
> > Signed-off-by: Samuil Ivanov <samuil.ivano...@gmail.com>
> > ---
> > drivers/staging/gasket/apex_driver.c | 3 +++
> > 1 file changed, 3 insertions(+)
> >
> > diff --git a/drivers/staging/gasket/apex_driver.c
> > b/drivers/staging/gasket/apex_driver.c
> > index 46199c8ca441..a5dd6f3c367d 100644
> > --- a/drivers/staging/gasket/apex_driver.c
> > +++ b/drivers/staging/gasket/apex_driver.c
> > @@ -247,6 +247,9 @@ module_param(bypass_top_level, int, 0644);
> > static int apex_get_status(struct gasket_dev *gasket_dev)
> > {
> > /* TODO: Check device status. */
> > + if (gasket_dev->status == GASKET_STATUS_DEAD)
> > + return GASKET_STATUS_DEAD;
> > +
>
> Have you tested this to verify that this is what is needed here?
>
> thanks,
>
> greg k-h
Hello Greg,
After going through the code again, I am sure this not what is needed here.
I thought that gasket_dev->status is already set to either
GASKET_STATUS_ALIVE of GASKET_STATUS_DEAD,
and all I needed to do is check it. It turns out that status
has to be set before that.
So what I found is that function gasket_get_hw_status()
in file gasket_core.c is used to determine the health of the Gasket device,
and other function use it to set gasket_dev->status and then check
the device status.
I think it should be something like this.
...
gasket_dev->status = gasket_get_hw_status(gasket_dev);
if (gasket_dev->status == GASKET_STATUS_DEAD) {
dev_dbg(gasket_dev->dev, "Device reported as dead.\n");
return -EINVAL;
}
return GASKET_STATUS_ALIVE;
...
I can try this, but I have no means of testing it.
Grt,
Samuil
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
