Device can be used over I2C bus, so it documents 'reg' property, however
it misses to constrain it to actual I2C address.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlow...@linaro.org>
---
Documentation/devicetree/bindings/display/bridge/ti,tdp158.yaml | 1 +
1 file changed, 1 insertion(+)
diff --git a/Documentation/devicetree/bindings/display/bridge/ti,tdp158.yaml
b/Documentation/devicetree/bindings/display/bridge/ti,tdp158.yaml
index
1c522f72c4bae3313930b5c76dd04dde1aef5151..721da44054e19ff04fe9d8c1dc31a9168e8f79f5
100644
--- a/Documentation/devicetree/bindings/display/bridge/ti,tdp158.yaml
+++ b/Documentation/devicetree/bindings/display/bridge/ti,tdp158.yaml
@@ -17,6 +17,7 @@ properties:
# The reg property is required if and only if the device is connected
# to an I2C bus. In pin strap mode, reg must not be specified.
reg:
+ maxItems: 1
description: I2C address of the device
# Pin 36 = Operation Enable / Reset Pin
--
2.48.1
