On Sun, Feb 23, 2025 at 05:32:44PM +0200, Svyatoslav Ryhel wrote:
> SSD2825 is a cost-effective MIPI Bridge Chip solution targeting mainly
> smartphones. It can convert 24bit RGB interface into 4-lane MIPI-DSI
> interface to drive display modules of up to 800 x 1366, while supporting
> AMOLED, a-si LCD or LTPS panel technologies for smartphone applications.
>
> Signed-off-by: Svyatoslav Ryhel <clamo...@gmail.com>
> ---
> drivers/gpu/drm/bridge/Kconfig | 13 +
> drivers/gpu/drm/bridge/Makefile | 1 +
> drivers/gpu/drm/bridge/ssd2825.c | 821 +++++++++++++++++++++++++++++++
> 3 files changed, 835 insertions(+)
> create mode 100644 drivers/gpu/drm/bridge/ssd2825.c
>
> +
> + if (buf == MIPI_DCS_SET_DISPLAY_ON) {
> + /*
> + * NOTE! This is here since it cannot be called in bridge
> enable because
> + * bridge pre enable and bridge enable have no gap in between.
> + *
> + * Existing framework bridge-panel seq is:
> + * panel_prepare > bridge_pre_enable > bridge_enable >
> panel_enable
> + *
> + * Using prepare_prev_first was tested, but it switches seq
> like this:
> + * bridge_pre_enable > panel_prepare > bridge_enable >
> panel_enable
> + *
> + * This will not work since panel hw MUST be prepared before
> bridge is
> + * configured. Correct seq should be:
> + * panel_prepare > bridge_pre_enable > panel_enable >
> bridge_enable
> + *
> + * Last two functions are swapped related to existing
> framework. I am not
> + * aware about method which allows that.
> + *
> + * Once there will be such method/flag, code below should be
> moved into
> + * bridge_enable since it is basically a bridge configuration
> completing
> + * after initial panel DSI sequence is completed.
Will bridge_pre_enable -> panel_prepare (including
MIPI_DCS_SET_DISPLAY_ON) -> bridge_enable work?
The rest looks good to me.
> + */
> + config = SSD2825_CONF_REG_HS | SSD2825_CONF_REG_DCS |
> + SSD2825_CONF_REG_ECD | SSD2825_CONF_REG_EOT;
> +
> + if (dsi_dev->mode_flags & MIPI_DSI_MODE_VIDEO)
> + config |= SSD2825_CONF_REG_VEN;
> +
> + if (dsi_dev->mode_flags & MIPI_DSI_MODE_NO_EOT_PACKET)
> + config &= ~SSD2825_CONF_REG_EOT;
> +
> + /* Complete configuration after DSI commands were sent */
> + ssd2825_write_reg(priv, SSD2825_CONFIGURATION_REG, config);
> + ssd2825_write_reg(priv, SSD2825_PLL_CTRL_REG, 0x0001);
> + ssd2825_write_reg(priv, SSD2825_VC_CTRL_REG, 0x0000);
> + }
> +
> + return 0;
> +}
> +
>
--
With best wishes
Dmitry
