On Mon, Dec 11, 2023 at 9:33 PM Adam Ford <aford...@gmail.com> wrote:
>
> When using video sync pulses, the HFP, HBP, and HSA are divided between
> the available lanes if there is more than one lane. For certain
> timings and lane configurations, the HFP may not be evenly divisible.
> If the HFP is rounded down, it ends up being too small which can cause
> some monitors to not sync properly. In these instances, adjust htotal
> and hsync to round the HFP up, and recalculate the htotal.
>
For anyone who's following this, I added a note which I apparently
forgot to save:
This adds support for 720p60 in the i.MX8M Plus.
NXP uses a look-up table in their downstream code to accomplish this.
Using this calculation, the driver can adjust without the need for a
complicated table and should be flexible for different timings and
resolutions depending on the monitor.
I don't have a DSI analyzer, and this appears to only work on
i.MX8M Plus but not Mini and Nano for some reason, despite their
having a similar DSI bridge.
When Frieder teste this, he reported no changes on the Kontrol BL
i.MX8MM: "So at least there is no negative impact in this case"
If someone else has an i.MX8MP, I would appreciate any feedback.
thanks
adam
> Tested-by: Frieder Schrempf <frieder.schre...@kontron.de> # Kontron BL
> i.MX8MM with HDMI monitor
> Signed-off-by: Adam Ford <aford...@gmail.com>
>
> diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c
> b/drivers/gpu/drm/bridge/samsung-dsim.c
> index 239d253a7d71..f5795da1d8bb 100644
> --- a/drivers/gpu/drm/bridge/samsung-dsim.c
> +++ b/drivers/gpu/drm/bridge/samsung-dsim.c
> @@ -1628,6 +1628,27 @@ static int samsung_dsim_atomic_check(struct drm_bridge
> *bridge,
> adjusted_mode->flags |= (DRM_MODE_FLAG_PHSYNC |
> DRM_MODE_FLAG_PVSYNC);
> }
>
> + /*
> + * When using video sync pulses, the HFP, HBP, and HSA are divided
> between
> + * the available lanes if there is more than one lane. For certain
> + * timings and lane configurations, the HFP may not be evenly
> divisible.
> + * If the HFP is rounded down, it ends up being too small which can
> cause
> + * some monitors to not sync properly. In these instances, adjust
> htotal
> + * and hsync to round the HFP up, and recalculate the htotal. Through
> trial
> + * and error, it appears that the HBP and HSA do not appearto need
> the same
> + * correction that HFP does.
> + */
> + if (dsi->mode_flags & MIPI_DSI_MODE_VIDEO_SYNC_PULSE && dsi->lanes >
> 1) {
> + int hfp = adjusted_mode->hsync_start -
> adjusted_mode->hdisplay;
> + int remainder = hfp % dsi->lanes;
> +
> + if (remainder) {
> + adjusted_mode->hsync_start += remainder;
> + adjusted_mode->hsync_end += remainder;
> + adjusted_mode->htotal += remainder;
> + }
> + }
> +
> return 0;
> }
>
> --
> 2.40.1
>
