On 10/07/2013 02:34 AM, Thierry Reding wrote:
> Add a driver for simple panels. Such panels can have a regulator that
> provides the supply voltage and a separate GPIO to enable the panel.
> Optionally the panels can have a backlight associated with them so it
> can be enabled or disabled according to the panel's power management
> mode.
>
> Support is added for three panels: An AU Optronics 10.1" WSVGA, a
> Chunghwa Picture Tubes 10.1" WXGA and a Panasonic 10.1 WUXGA TFT LCD
> panel.
> .../devicetree/bindings/panel/auo,b101aw03.txt | 7 +
> .../bindings/panel/chunghwa,claa101wb03.txt | 7 +
> .../bindings/panel/panasonic,vvx10f004b00.txt | 7 +
> .../devicetree/bindings/panel/simple-panel.txt | 21 ++
Since this patch defines new DT bindings, it should also be sent to the
DT binding maintainers and DT mailing list.
> diff --git a/drivers/gpu/drm/panel/panel-simple.c
> b/drivers/gpu/drm/panel/panel-simple.c
> +static int panel_simple_remove(struct platform_device *pdev)
> +{
> + struct panel_simple *panel = platform_get_drvdata(pdev);
> +
> + if (gpio_is_valid(panel->enable_gpio)) {
> + if (panel->enable_gpio_flags & GPIO_ACTIVE_LOW)
> + gpio_set_value(panel->enable_gpio, 1);
> + else
> + gpio_set_value(panel->enable_gpio, 0);
> +
> + gpio_free(panel->enable_gpio);
> + }
> +
> + regulator_disable(panel->supply);
Can you just call panel_simple_disable() to do the HW cleanup, and just
do resource cleanup here?
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/dri-devel
