On 05/06/2023 17:35, Paulo Pavacic wrote:
> Fannal C3004 is a 480x800 display made by fannal that requires
> DCS initialization sequences.
>
> Signed-off-by: Paulo Pavacic <pavaci...@gmail.com>
> ---
> v3 changelog:
> - using generic mipi_dsi_dcs_write_seq
This is marked as v2?
> - removed success prints
> - removed some comments
> - simplified code/removed support for different panels
> - changed namespace from fann to fannal
> v2 changelog:
> - renamed from panel-mipi-dsi-bringup
> - only one MAINTAINER e-mail
> ---
> MAINTAINERS
> +static int fannal_panel_probe(struct mipi_dsi_device *dsi)
> +{
> + struct device *dev = &dsi->dev;
> + struct fannal_panel_data *panel_data;
> + int ret;
> +
> + panel_data = devm_kzalloc(&dsi->dev, sizeof(*panel_data), GFP_KERNEL);
> +
> + if (!panel_data)
> + return -ENOMEM;
> +
> + panel_data->reset = devm_gpiod_get_optional(
> + dev, "reset", GPIOD_OUT_LOW | GPIOD_FLAGS_BIT_NONEXCLUSIVE);
dev should be in previous line
Why this is nonexclusive? How many instances of same driver are
expecting to get this on one system?
> +
> + if (IS_ERR(panel_data->reset)) {
> + ret = PTR_ERR(panel_data->reset);
> + dev_err(dev,
> + "error: probe: get reset GPIO: (%d) Check the fdt\n",
> + ret);
return dev_err_probe
> + return ret;
> + }
> +
> + mipi_dsi_set_drvdata(dsi, panel_data);
> +
> + dsi->format = MIPI_DSI_FMT_RGB888;
> + dsi->mode_flags = MIPI_DSI_CLOCK_NON_CONTINUOUS |
> + MIPI_DSI_MODE_VSYNC_FLUSH | MIPI_DSI_MODE_VIDEO_HSE |
> + MIPI_DSI_MODE_NO_EOT_PACKET |
> + MIPI_DSI_MODE_VIDEO_SYNC_PULSE | MIPI_DSI_MODE_VIDEO;
> + dsi->lanes = 2;
> +
> + gpiod_set_value_cansleep(panel_data->reset, 1);
So you leave the panel in reset state?
> +
> + drm_panel_init(&panel_data->panel, dev, &fannal_panel_funcs,
> + DRM_MODE_CONNECTOR_DSI);
> + dev_set_drvdata(dev, panel_data);
> +
> + drm_panel_add(&panel_data->panel);
> +
> + ret = mipi_dsi_attach(dsi);
> + if (ret) {
> + drm_panel_remove(&panel_data->panel);
> + dev_err(dev, "error: probe fail: can't attach mipi_dsi!\n");
No need to shout, skip exclamation mark.
Best regards,
Krzysztof
