On Wed, Aug 14, 2013 at 8:16 AM, Russell King - ARM Linux <li...@arm.linux.org.uk> wrote: > On Tue, Aug 06, 2013 at 12:20:11AM +0200, Sebastian Hesselbarth wrote: >> From: Russell King <rmk+ker...@arm.linux.org.uk> >> >> TDA19988 devices need their RAM enabled in order to read EDID >> information. Add support for this. >> >> Signed-off-by: Russell King <rmk+ker...@arm.linux.org.uk> >> Tested-by: Sebastian Hesselbarth <sebastian.hesselba...@gmail.com> > > There was some debate about whether this is needed or not. It seems that > if I don't run the NXP driver, it isn't needed, but if I have run the > NXP driver, then yes it is. As it seems to do no harm, I think it's fine > to be submitted.
just fwiw, I had noticed before that (at least on the beaglebone-black), nxp doesn't necessarily get reset when doing a warm reboot. So booting a kernel w/ NXP driver, and then rebooting w/ upstream kernel and tda998x should probably hit this same scenario. Better to not assume too much about the state of the tda when the driver is loaded, so I think this patch is a good idea. Signed-off-by: Rob Clark <robdcl...@gmail.com> BR, -R _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org http://lists.freedesktop.org/mailman/listinfo/dri-devel
