Hi, Markus:
On Mon, 2021-08-16 at 21:25 +0200, Markus Schneider-Pargmann wrote:
> This patch adds a DisplayPort driver for the Mediatek mt8195 SoC.
>
> It supports both functional units on the mt8195, the embedded
> DisplayPort as well as the external DisplayPort units. It offers
> hot-plug-detection, audio up to 8 channels, and DisplayPort 1.4 with up
> to 4 lanes.
>
> This driver is based on an initial version by
> Jason-JH.Lin <jason-jh....@mediatek.com>.
>
> Signed-off-by: Markus Schneider-Pargmann <m...@baylibre.com>
> ---
[snip]
> +
> +static const struct of_device_id mtk_dp_of_match[] = {
> + {
> + .compatible = "mediatek,mt8195-dp_tx",
Where is the binding document of "mediatek,mt8195-dp_tx"?
> + .data = &mt8195_dp_driver_data,
> + },
> + {
> + .compatible = "mediatek,mt8195-edp_tx",
Where is the binding document of "mediatek,mt8195-edp_tx"?
> + .data = &mt8195_edp_driver_data,
> + },
> + {},
> +};
> +MODULE_DEVICE_TABLE(of, mtk_dp_of_match);
> +
> +struct platform_driver mtk_dp_driver = {
> + .probe = mtk_dp_probe,
> + .remove = mtk_dp_remove,
> + .driver = {
> + .name = "mediatek-drm-dp",
> + .of_match_table = mtk_dp_of_match,
> + .pm = &mtk_dp_pm_ops,
> + },
> +};
> +
> diff --git a/drivers/gpu/drm/mediatek/mtk_dp_reg.h
> b/drivers/gpu/drm/mediatek/mtk_dp_reg.h
> new file mode 100644
> index 000000000000..83afc79d98ff
> --- /dev/null
> +++ b/drivers/gpu/drm/mediatek/mtk_dp_reg.h
> @@ -0,0 +1,3095 @@
> +/* SPDX-License-Identifier: GPL-2.0 */
> +/*
> + * Copyright (c) 2019 MediaTek Inc.
> + * Copyright (c) 2021 BayLibre
> + */
> +#ifndef _MTK_DP_REG_H_
> +#define _MTK_DP_REG_H_
> +
> +#define MTK_DP_SIP_CONTROL_AARCH32 0x82000523
> +# define MTK_DP_SIP_ATF_VIDEO_UNMUTE 0x20
> +# define MTK_DP_SIP_ATF_EDP_VIDEO_UNMUTE 0x21
> +# define MTK_DP_SIP_ATF_REG_WRITE 0x22
> +# define MTK_DP_SIP_ATF_REG_READ 0x23
> +# define MTK_DP_SIP_ATF_CMD_COUNT 0x24
> +
> +#define TOP_OFFSET 0x2000
> +#define ENC0_OFFSET 0x3000
> +#define ENC1_OFFSET 0x3200
> +#define TRANS_OFFSET 0x3400
> +#define AUX_OFFSET 0x3600
> +#define SEC_OFFSET 0x4000
> +
> +#define MTK_DP_HPD_DISCONNECT BIT(1)
> +#define MTK_DP_HPD_CONNECT BIT(2)
> +#define MTK_DP_HPD_INTERRUPT BIT(3)
> +
> +#define MTK_DP_ENC0_P0_3000 (ENC0_OFFSET + 0x000)
> +# define LANE_NUM_DP_ENC0_P0_MASK 0x3
> +# define LANE_NUM_DP_ENC0_P0_SHIFT 0
> +# define VIDEO_MUTE_SW_DP_ENC0_P0_MASK 0x4
> +# define VIDEO_MUTE_SW_DP_ENC0_P0_SHIFT 2
> +# define VIDEO_MUTE_SEL_DP_ENC0_P0_MASK 0x8
> +# define VIDEO_MUTE_SEL_DP_ENC0_P0_SHIFT 3
> +# define ENHANCED_FRAME_EN_DP_ENC0_P0_MASK 0x10
> +# define ENHANCED_FRAME_EN_DP_ENC0_P0_SHIFT 4
> +# define HDCP_FRAME_EN_DP_ENC0_P0_MASK 0x20
> +# define HDCP_FRAME_EN_DP_ENC0_P0_SHIFT 5
> +# define IDP_EN_DP_ENC0_P0_MASK 0x40
Remove useless definition.
Regards,
CK.
> +# define IDP_EN_DP_ENC0_P0_SHIFT 6
> +# define BS_SYMBOL_CNT_RESET_DP_ENC0_P0_MASK 0x80
> +# define BS_SYMBOL_CNT_RESET_DP_ENC0_P0_SHIFT 7
> +# define MIXER_DUMMY_DATA_DP_ENC0_P0_MASK 0xff00
> +# define MIXER_DUMMY_DATA_DP_ENC0_P0_SHIFT 8
> +
> +
> +#endif /*_MTK_DP_REG_H_*/
