Hi Neil,
On Thu, 2021-04-22 at 10:48 +0200, Neil Armstrong wrote:
> Hi,
>
> On 22/04/2021 07:14, Liu Ying wrote:
> > Some MIPI DSI panel drivers like 'raydium,rm68200' send
> > MIPI_DCS_SET_DISPLAY_ON commands in panel_funcs->prepare(), which
> > requires the MIPI DSI controller and PHY to be ready beforehand.
> > Without this patch, the nwl-dsi driver gets the MIPI DSI controller
> > and PHY ready in bridge_funcs->pre_enable(), which happens after
> > the panel_funcs->prepare(). So, this patch shifts the bridge operation
> > ealier from bridge_funcs->pre_enable() to bridge_funcs->mode_set().
>
> This makes sense, this is how we do on the synopsys dw mipi dsi driver.
>
> > This way, more MIPI DSI panels can connect to this nwl-dsi bridge.
> > Care is taken to make sure bridge_funcs->mode_set()/atomic_disable()
> > are called in pairs, which includes removing a check on unchanged HS
> > clock rate and forcing a full modeset when only connector's DPMS is
> > brought out of "Off" status.
>
> I would split the changes in multiple patches to clarify the changes.
Maybe, I can split this into the below 3 patches:
1) Remove a check on unchanged HS clock rate from ->mode_set().
2) Force a full modeset when only connector's DPMS is brought out of
"Off" status. This will be done in ->atomic_check() together with the
fixup for H/VSYNC polarities.
3) Shift the bridge operation as the last step.
I'll mention that 1) & 2) are needed by 3) in their commit message.
Does this split-up sound reasonable?
Thanks,
Liu Ying
>
> Neil
>
> > Cc: Andrzej Hajda <a.ha...@samsung.com>
> > Cc: Neil Armstrong <narmstr...@baylibre.com>
> > Cc: Robert Foss <robert.f...@linaro.org>
> > Cc: Laurent Pinchart <laurent.pinch...@ideasonboard.com>
> > Cc: Jonas Karlman <jo...@kwiboo.se>
> > Cc: Jernej Skrabec <jernej.skra...@siol.net>
> > Cc: David Airlie <airl...@linux.ie>
> > Cc: Daniel Vetter <dan...@ffwll.ch>
> > Cc: Guido Günther <a...@sigxcpu.org>
> > Cc: Robert Chiras <robert.chi...@nxp.com>
> > Cc: NXP Linux Team <linux-...@nxp.com>
> > Signed-off-by: Liu Ying <victor....@nxp.com>
> > ---
> > v1->v2:
> > * Fix commit message typo - s/unchange/unchanged/
> >
> > drivers/gpu/drm/bridge/nwl-dsi.c | 86
> > +++++++++++++++++++++-------------------
> > 1 file changed, 46 insertions(+), 40 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/bridge/nwl-dsi.c
> > b/drivers/gpu/drm/bridge/nwl-dsi.c
> > index be6bfc5..229f0b1 100644
> > --- a/drivers/gpu/drm/bridge/nwl-dsi.c
> > +++ b/drivers/gpu/drm/bridge/nwl-dsi.c
> > @@ -21,6 +21,7 @@
> > #include <linux/sys_soc.h>
> > #include <linux/time64.h>
> >
> > +#include <drm/drm_atomic_state_helper.h>
> > #include <drm/drm_bridge.h>
> > #include <drm/drm_mipi_dsi.h>
> > #include <drm/drm_of.h>
> > @@ -661,7 +662,7 @@ static irqreturn_t nwl_dsi_irq_handler(int irq, void
> > *data)
> > return IRQ_HANDLED;
> > }
> >
> > -static int nwl_dsi_enable(struct nwl_dsi *dsi)
> > +static int nwl_dsi_mode_set(struct nwl_dsi *dsi)
> > {
> > struct device *dev = dsi->dev;
> > union phy_configure_opts *phy_cfg = &dsi->phy_cfg;
> > @@ -748,7 +749,9 @@ static int nwl_dsi_disable(struct nwl_dsi *dsi)
> > return 0;
> > }
> >
> > -static void nwl_dsi_bridge_disable(struct drm_bridge *bridge)
> > +static void
> > +nwl_dsi_bridge_atomic_disable(struct drm_bridge *bridge,
> > + struct drm_bridge_state *old_bridge_state)
> > {
> > struct nwl_dsi *dsi = bridge_to_dsi(bridge);
> > int ret;
> > @@ -809,17 +812,6 @@ static int nwl_dsi_get_dphy_params(struct nwl_dsi *dsi,
> > return 0;
> > }
> >
> > -static bool nwl_dsi_bridge_mode_fixup(struct drm_bridge *bridge,
> > - const struct drm_display_mode *mode,
> > - struct drm_display_mode *adjusted_mode)
> > -{
> > - /* At least LCDIF + NWL needs active high sync */
> > - adjusted_mode->flags |= (DRM_MODE_FLAG_PHSYNC | DRM_MODE_FLAG_PVSYNC);
> > - adjusted_mode->flags &= ~(DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC);
> > -
> > - return true;
> > -}
> > -
> > static enum drm_mode_status
> > nwl_dsi_bridge_mode_valid(struct drm_bridge *bridge,
> > const struct drm_display_info *info,
> > @@ -837,6 +829,29 @@ nwl_dsi_bridge_mode_valid(struct drm_bridge *bridge,
> > return MODE_OK;
> > }
> >
> > +static int nwl_dsi_bridge_atomic_check(struct drm_bridge *bridge,
> > + struct drm_bridge_state *bridge_state,
> > + struct drm_crtc_state *crtc_state,
> > + struct drm_connector_state *conn_state)
> > +{
> > + struct drm_display_mode *adjusted_mode = &crtc_state->adjusted_mode;
> > +
> > + /* At least LCDIF + NWL needs active high sync */
> > + adjusted_mode->flags |= (DRM_MODE_FLAG_PHSYNC | DRM_MODE_FLAG_PVSYNC);
> > + adjusted_mode->flags &= ~(DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC);
> > +
> > + /*
> > + * Do a full modeset if crtc_state->active is changed to be true.
> > + * This ensures our ->mode_set() is called to get the DSI controller
> > + * and the PHY ready to send DCS commands, when only the connector's
> > + * DPMS is brought out of "Off" status.
> > + */
> > + if (crtc_state->active_changed && crtc_state->active)
> > + crtc_state->mode_changed = true;
> > +
> > + return 0;
> > +}
> > +
> > static void
> > nwl_dsi_bridge_mode_set(struct drm_bridge *bridge,
> > const struct drm_display_mode *mode,
> > @@ -852,13 +867,6 @@ nwl_dsi_bridge_mode_set(struct drm_bridge *bridge,
> > if (ret < 0)
> > return;
> >
> > - /*
> > - * If hs clock is unchanged, we're all good - all parameters are
> > - * derived from it atm.
> > - */
> > - if (new_cfg.mipi_dphy.hs_clk_rate == dsi->phy_cfg.mipi_dphy.hs_clk_rate)
> > - return;
> > -
> > phy_ref_rate = clk_get_rate(dsi->phy_ref_clk);
> > DRM_DEV_DEBUG_DRIVER(dev, "PHY at ref rate: %lu\n", phy_ref_rate);
> > /* Save the new desired phy config */
> > @@ -866,14 +874,8 @@ nwl_dsi_bridge_mode_set(struct drm_bridge *bridge,
> >
> > memcpy(&dsi->mode, adjusted_mode, sizeof(dsi->mode));
> > drm_mode_debug_printmodeline(adjusted_mode);
> > -}
> >
> > -static void nwl_dsi_bridge_pre_enable(struct drm_bridge *bridge)
> > -{
> > - struct nwl_dsi *dsi = bridge_to_dsi(bridge);
> > - int ret;
> > -
> > - pm_runtime_get_sync(dsi->dev);
> > + pm_runtime_get_sync(dev);
> >
> > if (clk_prepare_enable(dsi->lcdif_clk) < 0)
> > return;
> > @@ -883,27 +885,29 @@ static void nwl_dsi_bridge_pre_enable(struct
> > drm_bridge *bridge)
> > /* Step 1 from DSI reset-out instructions */
> > ret = reset_control_deassert(dsi->rst_pclk);
> > if (ret < 0) {
> > - DRM_DEV_ERROR(dsi->dev, "Failed to deassert PCLK: %d\n", ret);
> > + DRM_DEV_ERROR(dev, "Failed to deassert PCLK: %d\n", ret);
> > return;
> > }
> >
> > /* Step 2 from DSI reset-out instructions */
> > - nwl_dsi_enable(dsi);
> > + nwl_dsi_mode_set(dsi);
> >
> > /* Step 3 from DSI reset-out instructions */
> > ret = reset_control_deassert(dsi->rst_esc);
> > if (ret < 0) {
> > - DRM_DEV_ERROR(dsi->dev, "Failed to deassert ESC: %d\n", ret);
> > + DRM_DEV_ERROR(dev, "Failed to deassert ESC: %d\n", ret);
> > return;
> > }
> > ret = reset_control_deassert(dsi->rst_byte);
> > if (ret < 0) {
> > - DRM_DEV_ERROR(dsi->dev, "Failed to deassert BYTE: %d\n", ret);
> > + DRM_DEV_ERROR(dev, "Failed to deassert BYTE: %d\n", ret);
> > return;
> > }
> > }
> >
> > -static void nwl_dsi_bridge_enable(struct drm_bridge *bridge)
> > +static void
> > +nwl_dsi_bridge_atomic_enable(struct drm_bridge *bridge,
> > + struct drm_bridge_state *old_bridge_state)
> > {
> > struct nwl_dsi *dsi = bridge_to_dsi(bridge);
> > int ret;
> > @@ -948,14 +952,16 @@ static void nwl_dsi_bridge_detach(struct drm_bridge
> > *bridge)
> > }
> >
> > static const struct drm_bridge_funcs nwl_dsi_bridge_funcs = {
> > - .pre_enable = nwl_dsi_bridge_pre_enable,
> > - .enable = nwl_dsi_bridge_enable,
> > - .disable = nwl_dsi_bridge_disable,
> > - .mode_fixup = nwl_dsi_bridge_mode_fixup,
> > - .mode_set = nwl_dsi_bridge_mode_set,
> > - .mode_valid = nwl_dsi_bridge_mode_valid,
> > - .attach = nwl_dsi_bridge_attach,
> > - .detach = nwl_dsi_bridge_detach,
> > + .atomic_duplicate_state = drm_atomic_helper_bridge_duplicate_state,
> > + .atomic_destroy_state = drm_atomic_helper_bridge_destroy_state,
> > + .atomic_reset = drm_atomic_helper_bridge_reset,
> > + .atomic_check = nwl_dsi_bridge_atomic_check,
> > + .atomic_enable = nwl_dsi_bridge_atomic_enable,
> > + .atomic_disable = nwl_dsi_bridge_atomic_disable,
> > + .mode_set = nwl_dsi_bridge_mode_set,
> > + .mode_valid = nwl_dsi_bridge_mode_valid,
> > + .attach = nwl_dsi_bridge_attach,
> > + .detach = nwl_dsi_bridge_detach,
> > };
> >
> > static int nwl_dsi_parse_dt(struct nwl_dsi *dsi)
> >
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
