Hi Sam,
Thank you for the patch.
On Sun, Jul 26, 2020 at 10:33:17PM +0200, Sam Ravnborg wrote:
> Prepare the bridge driver for use in a chained setup by
> replacing direct use of drm_panel with drm_panel_bridge support.
>
> The connecter is now either created by the panel bridge or the display
> driver. So all code for connector creation in this driver is no longer
> relevant and thus dropped.
>
> The connector code had some special polling handling:
> connector.polled = DRM_CONNECTOR_POLL_HPD;
> drm_helper_hpd_irq_event(ps8622->bridge.dev);
>
> This code was most likely added to speed up detection of the connector.
> If really needed then this functionality belongs somewhere else.
>
> Note: the bridge panel will use the connector type from the panel.
>
> v2:
> - Fix to avoid creating connector twice (Laurent)
> - Drop all connector code - defer to bridge panel
> - Use panel_bridge for local variable to align with other drivers
> - Set bridge.type to DRM_MODE_CONNECTOR_LVDS;
>
> Signed-off-by: Sam Ravnborg <s...@ravnborg.org>
> Cc: Andrzej Hajda <a.ha...@samsung.com>
> Cc: Neil Armstrong <narmstr...@baylibre.com>
> Cc: Laurent Pinchart <laurent.pinch...@ideasonboard.com>
> Cc: Jonas Karlman <jo...@kwiboo.se>
> Cc: Jernej Skrabec <jernej.skra...@siol.net>
> ---
> drivers/gpu/drm/bridge/parade-ps8622.c | 100 ++++---------------------
> 1 file changed, 13 insertions(+), 87 deletions(-)
>
> diff --git a/drivers/gpu/drm/bridge/parade-ps8622.c
> b/drivers/gpu/drm/bridge/parade-ps8622.c
> index d789ea2a7fb9..614b19f0f1b7 100644
> --- a/drivers/gpu/drm/bridge/parade-ps8622.c
> +++ b/drivers/gpu/drm/bridge/parade-ps8622.c
> @@ -42,10 +42,9 @@
> #endif
>
> struct ps8622_bridge {
> - struct drm_connector connector;
> struct i2c_client *client;
> struct drm_bridge bridge;
> - struct drm_panel *panel;
> + struct drm_bridge *panel_bridge;
> struct regulator *v12;
> struct backlight_device *bl;
>
> @@ -64,12 +63,6 @@ static inline struct ps8622_bridge *
> return container_of(bridge, struct ps8622_bridge, bridge);
> }
>
> -static inline struct ps8622_bridge *
> - connector_to_ps8622(struct drm_connector *connector)
> -{
> - return container_of(connector, struct ps8622_bridge, connector);
> -}
> -
> static int ps8622_set(struct i2c_client *client, u8 page, u8 reg, u8 val)
> {
> int ret;
> @@ -365,11 +358,6 @@ static void ps8622_pre_enable(struct drm_bridge *bridge)
> DRM_ERROR("fails to enable ps8622->v12");
> }
>
> - if (drm_panel_prepare(ps8622->panel)) {
> - DRM_ERROR("failed to prepare panel\n");
> - return;
> - }
> -
> gpiod_set_value(ps8622->gpio_slp, 1);
>
> /*
> @@ -399,24 +387,9 @@ static void ps8622_pre_enable(struct drm_bridge *bridge)
> ps8622->enabled = true;
> }
>
> -static void ps8622_enable(struct drm_bridge *bridge)
> -{
> - struct ps8622_bridge *ps8622 = bridge_to_ps8622(bridge);
> -
> - if (drm_panel_enable(ps8622->panel)) {
> - DRM_ERROR("failed to enable panel\n");
> - return;
> - }
> -}
> -
> static void ps8622_disable(struct drm_bridge *bridge)
> {
> - struct ps8622_bridge *ps8622 = bridge_to_ps8622(bridge);
> -
> - if (drm_panel_disable(ps8622->panel)) {
> - DRM_ERROR("failed to disable panel\n");
> - return;
> - }
> + /* Delay after panel is disabled */
> msleep(PS8622_PWMO_END_T12_MS);
I really don't understand why a delay would be needed here.
Reviewed-by: Laurent Pinchart <laurent.pinch...@ideasonboard.com>
> }
>
> @@ -436,11 +409,6 @@ static void ps8622_post_disable(struct drm_bridge
> *bridge)
> */
> gpiod_set_value(ps8622->gpio_slp, 0);
>
> - if (drm_panel_unprepare(ps8622->panel)) {
> - DRM_ERROR("failed to unprepare panel\n");
> - return;
> - }
> -
> if (ps8622->v12)
> regulator_disable(ps8622->v12);
>
> @@ -455,67 +423,17 @@ static void ps8622_post_disable(struct drm_bridge
> *bridge)
> msleep(PS8622_POWER_OFF_T17_MS);
> }
>
> -static int ps8622_get_modes(struct drm_connector *connector)
> -{
> - struct ps8622_bridge *ps8622;
> -
> - ps8622 = connector_to_ps8622(connector);
> -
> - return drm_panel_get_modes(ps8622->panel, connector);
> -}
> -
> -static const struct drm_connector_helper_funcs ps8622_connector_helper_funcs
> = {
> - .get_modes = ps8622_get_modes,
> -};
> -
> -static const struct drm_connector_funcs ps8622_connector_funcs = {
> - .fill_modes = drm_helper_probe_single_connector_modes,
> - .destroy = drm_connector_cleanup,
> - .reset = drm_atomic_helper_connector_reset,
> - .atomic_duplicate_state = drm_atomic_helper_connector_duplicate_state,
> - .atomic_destroy_state = drm_atomic_helper_connector_destroy_state,
> -};
> -
> static int ps8622_attach(struct drm_bridge *bridge,
> enum drm_bridge_attach_flags flags)
> {
> struct ps8622_bridge *ps8622 = bridge_to_ps8622(bridge);
> - int ret;
> -
> - if (flags & DRM_BRIDGE_ATTACH_NO_CONNECTOR) {
> - DRM_ERROR("Fix bridge driver to make connector optional!");
> - return -EINVAL;
> - }
>
> - if (!bridge->encoder) {
> - DRM_ERROR("Parent encoder object not found");
> - return -ENODEV;
> - }
> -
> - ps8622->connector.polled = DRM_CONNECTOR_POLL_HPD;
> - ret = drm_connector_init(bridge->dev, &ps8622->connector,
> - &ps8622_connector_funcs, DRM_MODE_CONNECTOR_LVDS);
> - if (ret) {
> - DRM_ERROR("Failed to initialize connector with drm\n");
> - return ret;
> - }
> - drm_connector_helper_add(&ps8622->connector,
> - &ps8622_connector_helper_funcs);
> - drm_connector_register(&ps8622->connector);
> - drm_connector_attach_encoder(&ps8622->connector,
> - bridge->encoder);
> -
> - if (ps8622->panel)
> - drm_panel_attach(ps8622->panel, &ps8622->connector);
> -
> - drm_helper_hpd_irq_event(ps8622->connector.dev);
> -
> - return ret;
> + return drm_bridge_attach(ps8622->bridge.encoder, ps8622->panel_bridge,
> + &ps8622->bridge, flags);
> }
>
> static const struct drm_bridge_funcs ps8622_bridge_funcs = {
> .pre_enable = ps8622_pre_enable,
> - .enable = ps8622_enable,
> .disable = ps8622_disable,
> .post_disable = ps8622_post_disable,
> .attach = ps8622_attach,
> @@ -533,16 +451,23 @@ static int ps8622_probe(struct i2c_client *client,
> {
> struct device *dev = &client->dev;
> struct ps8622_bridge *ps8622;
> + struct drm_bridge *panel_bridge;
> + struct drm_panel *panel;
> int ret;
>
> ps8622 = devm_kzalloc(dev, sizeof(*ps8622), GFP_KERNEL);
> if (!ps8622)
> return -ENOMEM;
>
> - ret = drm_of_find_panel_or_bridge(dev->of_node, 0, 0, &ps8622->panel,
> NULL);
> + ret = drm_of_find_panel_or_bridge(dev->of_node, 0, 0, &panel, NULL);
> if (ret)
> return ret;
>
> + panel_bridge = devm_drm_panel_bridge_add(dev, panel);
> + if (IS_ERR(panel_bridge))
> + return PTR_ERR(panel_bridge);
> +
> + ps8622->panel_bridge = panel_bridge;
> ps8622->client = client;
>
> ps8622->v12 = devm_regulator_get(dev, "vdd12");
> @@ -595,6 +520,7 @@ static int ps8622_probe(struct i2c_client *client,
> }
>
> ps8622->bridge.funcs = &ps8622_bridge_funcs;
> + ps8622->bridge.type = DRM_MODE_CONNECTOR_LVDS;
> ps8622->bridge.of_node = dev->of_node;
> drm_bridge_add(&ps8622->bridge);
>
--
Regards,
Laurent Pinchart
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
