On BCM2711 to avoid stale pixels getting stuck in intermediate FIFOs, the
pixelvalve needs to be setup each time there's a mode change or enable /
disable sequence.
Therefore, we can't really use mode_set_nofb anymore to configure it, but
we need to move it to atomic_enable.
Signed-off-by: Maxime Ripard <max...@cerno.tech>
---
drivers/gpu/drm/vc4/vc4_crtc.c | 12 +++---------
1 file changed, 3 insertions(+), 9 deletions(-)
diff --git a/drivers/gpu/drm/vc4/vc4_crtc.c b/drivers/gpu/drm/vc4/vc4_crtc.c
index a69e0d456b79..08bd595f6a7c 100644
--- a/drivers/gpu/drm/vc4/vc4_crtc.c
+++ b/drivers/gpu/drm/vc4/vc4_crtc.c
@@ -374,14 +374,6 @@ static void vc4_crtc_config_pv(struct drm_crtc *crtc)
}
}
-static void vc4_crtc_mode_set_nofb(struct drm_crtc *crtc)
-{
- struct vc4_crtc_state *vc4_state = to_vc4_crtc_state(crtc->state);
-
- if (!vc4_state->feed_txp)
- vc4_crtc_config_pv(crtc);
-}
-
static void require_hvs_enabled(struct drm_device *dev)
{
struct vc4_dev *vc4 = to_vc4_dev(dev);
@@ -443,6 +435,9 @@ static void vc4_crtc_atomic_enable(struct drm_crtc *crtc,
vc4_crtc_pixelvalve_reset(crtc);
+ if (!vc4_state->feed_txp)
+ vc4_crtc_config_pv(crtc);
+
CRTC_WRITE(PV_CONTROL, CRTC_READ(PV_CONTROL) | PV_CONTROL_EN);
/* Enable vblank irq handling before crtc is started otherwise
@@ -814,7 +809,6 @@ static const struct drm_crtc_funcs vc4_crtc_funcs = {
};
static const struct drm_crtc_helper_funcs vc4_crtc_helper_funcs = {
- .mode_set_nofb = vc4_crtc_mode_set_nofb,
.mode_valid = vc4_crtc_mode_valid,
.atomic_check = vc4_crtc_atomic_check,
.atomic_flush = vc4_hvs_atomic_flush,
--
git-series 0.9.1
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
