Hi Laurent,

Den 11.08.2019 15.35, skrev Laurent Pinchart:
> Hi Noralf,
> 
> On Sun, Aug 11, 2019 at 03:19:13PM +0200, Noralf Trønnes wrote:
>> Sam,
>>
>> Den 11.08.2019 01.10, skrev Laurent Pinchart:
>>> This panel is used on the Gumstix Overo Palo35.
>>>
>>> The code is based on the omapdrm-specific panel-lgphilips-lb035q02
>>> driver.
>>>
>>> Signed-off-by: Laurent Pinchart <laurent.pinch...@ideasonboard.com>
>>> Reviewed-by: Sam Ravnborg <s...@ravnborg.org>
>>> ---
>>
>> <snip>
>>
>>> diff --git a/drivers/gpu/drm/panel/panel-lg-lb035q02.c 
>>> b/drivers/gpu/drm/panel/panel-lg-lb035q02.c
>>
>> <snip>
>>
>>> +static int lb035q02_write(struct lb035q02_device *lcd, u16 reg, u16 val)
>>> +{
>>> +   struct spi_message msg;
>>> +   struct spi_transfer index_xfer = {
>>> +           .len            = 3,
>>> +           .cs_change      = 1,
>>> +   };
>>> +   struct spi_transfer value_xfer = {
>>> +           .len            = 3,
>>> +   };
>>> +   u8      buffer[16];
>>> +
>>> +   spi_message_init(&msg);
>>> +
>>> +   /* register index */
>>> +   buffer[0] = 0x70;
>>> +   buffer[1] = 0x00;
>>> +   buffer[2] = reg & 0x7f;
>>> +   index_xfer.tx_buf = buffer;
>>> +   spi_message_add_tail(&index_xfer, &msg);
>>> +
>>> +   /* register value */
>>> +   buffer[4] = 0x72;
>>> +   buffer[5] = val >> 8;
>>> +   buffer[6] = val;
>>> +   value_xfer.tx_buf = buffer + 4;
>>> +   spi_message_add_tail(&value_xfer, &msg);
>>> +
>>> +   return spi_sync(lcd->spi, &msg);
>>> +}
>>
>> Just a note to Sam:
>> This is the same spi protocol that the ili9325 controller on the hy28b
>> panel uses.
>>
>> I remembered that I have experimented with a regmap implementation:
>> https://github.com/notro/tinydrm/blob/master/tinydrm-ili9325.c#L191
> 
> That's useful information, thanks. The controller seems different
> though, the limited information available in
> https://www.beyondinfinite.com/lcd/Library/LG-Philips/LB035Q02.pdf
> doesn't match the registers from
> https://github.com/notro/tinydrm/blob/master/fb_ili9325.c.
> 

I've seen several controllers that use this protocol, and one that had a
different start byte configuration. The details unfortunately is lost in
time, it's been a while since I worked on these controllers.

Noralf.
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel

Reply via email to