Hi Robert.
Thanks for the contribution.
On Tue, Jun 18, 2019 at 04:30:45PM +0300, Robert Chiras wrote:
> Add dt-bindings documentation for Raydium RM67191 DSI panel.
>
> Signed-off-by: Robert Chiras <robert.chi...@nxp.com>
> ---
> .../bindings/display/panel/raydium,rm67191.txt | 43
> ++++++++++++++++++++++
> 1 file changed, 43 insertions(+)
> create mode 100644
> Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
>
> diff --git
> a/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
> b/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
> new file mode 100644
> index 0000000..0952610
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
> @@ -0,0 +1,43 @@
> +Raydium RM67171 OLED LCD panel with MIPI-DSI protocol
> +
> +Required properties:
> +- compatible: "raydium,rm67191"
> +- reg: virtual channel for MIPI-DSI protocol
> + must be <0>
> +- dsi-lanes: number of DSI lanes to be used
> + must be <3> or <4>
> +- port: input port node with endpoint definition as
> + defined in Documentation/devicetree/bindings/graph.txt;
> + the input port should be connected to a MIPI-DSI device
> + driver
> +
> +Optional properties:
> +- reset-gpios: a GPIO spec for the RST_B GPIO pin
> +- pinctrl-0 phandle to the pin settings for the reset pin
pinctrl is not included in bindings, they are implicit.
> +- width-mm: physical panel width [mm]
> +- height-mm: physical panel height [mm]
Please refer to panel-common.txt for the above.
> +- display-timings: timings for the connected panel according to [1]
> +- video-mode: 0 - burst-mode
> + 1 - non-burst with sync event
> + 2 - non-burst with sync pulse
> +
> +[1]: Documentation/devicetree/bindings/display/panel/display-timing.txt
> +
> +Example:
> +
> + panel@0 {
> + compatible = "raydium,rm67191";
> + reg = <0>;
> + pinctrl-0 = <&pinctrl_mipi_dsi_0_1_en>;
> + pinctrl-names = "default";
> + reset-gpios = <&gpio1 7 GPIO_ACTIVE_LOW>;
> + dsi-lanes = <4>;
> + width-mm = <68>;
> + height-mm = <121>;
> +
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&mipi_out>;
> + };
> + };
> + };
With the above fixed:
Signed-off-by: Sam Ravnborg <s...@ravnborg.org>
Note: You need r-b from DT maintainer before we can apply it.
Sam
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
