Hi Jitao

Always good to see more panels added.

On Sat, Jun 08, 2019 at 03:02:29PM +0800, Jitao Shi wrote:
> Add documentation for boe tv101wum-n16 panel.

The changelog says tv101wum-n16 but the compatible says tv101wum-nl6.
Please pick the right one and be consistent. (number one '1' versus
character 'l')

> 
> Signed-off-by: Jitao Shi <jitao....@mediatek.com>
> ---
>  .../display/panel/boe,tv101wum-nl6.txt        | 34 +++++++++++++++++++
>  1 file changed, 34 insertions(+)
>  create mode 100644 
> Documentation/devicetree/bindings/display/panel/boe,tv101wum-nl6.txt
> 
> diff --git 
> a/Documentation/devicetree/bindings/display/panel/boe,tv101wum-nl6.txt 
> b/Documentation/devicetree/bindings/display/panel/boe,tv101wum-nl6.txt
> new file mode 100644
> index 000000000000..2a84735d742d
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/display/panel/boe,tv101wum-nl6.txt
> @@ -0,0 +1,34 @@
> +Boe Corporation 10.1" WUXGA TFT LCD panel
> +
> +Required properties:
> +- compatible: should be "boe,tv101wum"
The example uses "boe,tv101wum-nl6", which matches the filename.
Please fix so it is the same all over.

> +- reg: the virtual channel number of a DSI peripheral
> +- enable-gpios: a GPIO spec for the enable pin
> +- pp1800-supply: core voltage supply
> +- avdd-supply: 
> +- avee-supply: 
Missing descriptions - please add.
> +- backlight: phandle of the backlight device attached to the panel
> +
> +The device node can contain one 'port' child node with one child
> +'endpoint' node, according to the bindings defined in
> +media/video-interfaces.txt. This node should describe panel's video bus.
> +
> +Example:
> +&dsi {
> +     ...
> +     panel@0 {
> +             compatible = "boe,tv101wum-nl6";
> +             reg = <0>;
> +             enable-gpios = <&pio 45 0>;
> +             avdd-supply = <&ppvarn_lcd>;
> +             avee-supply = <&ppvarp_lcd>;
> +             pp1800-supply = <&pp1800_lcd>;
> +             backlight = <&backlight_lcd0>;
> +             status = "okay";
> +             port {
> +                     panel_in: endpoint {
> +                             remote-endpoint = <&dsi_out>;
> +                     };
> +             };
> +     };
> +};
> \ No newline at end of file
Please add newline.

        Sam
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel

Reply via email to