Hi Tomi,
Thank you for the patch.
On Tue, Mar 26, 2019 at 12:31:31PM +0200, Tomi Valkeinen wrote:
> The driver currently sets the video stream registers in
> tc_main_link_setup. One should be able to establish the DP link without
> any video stream, so a more logical place is to configure the stream in
> the tc_main_link_stream. So move them there.
>
> Signed-off-by: Tomi Valkeinen <tomi.valkei...@ti.com>
> ---
> drivers/gpu/drm/bridge/tc358767.c | 18 +++++++++---------
> 1 file changed, 9 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/gpu/drm/bridge/tc358767.c
> b/drivers/gpu/drm/bridge/tc358767.c
> index f5c232a9064e..86b272422281 100644
> --- a/drivers/gpu/drm/bridge/tc358767.c
> +++ b/drivers/gpu/drm/bridge/tc358767.c
> @@ -1003,15 +1003,6 @@ static int tc_main_link_setup(struct tc_data *tc)
> return -EAGAIN;
> }
>
> - ret = tc_set_video_mode(tc, tc->mode);
> - if (ret)
> - goto err;
> -
> - /* Set M/N */
> - ret = tc_stream_clock_calc(tc);
> - if (ret)
> - goto err;
> -
> return 0;
> err_dpcd_read:
> dev_err(tc->dev, "Failed to read DPCD: %d\n", ret);
> @@ -1030,6 +1021,15 @@ static int tc_main_link_stream(struct tc_data *tc, int
> state)
> dev_dbg(tc->dev, "stream: %d\n", state);
>
> if (state) {
> + ret = tc_set_video_mode(tc, tc->mode);
> + if (ret)
> + goto err;
> +
> + /* Set M/N */
> + ret = tc_stream_clock_calc(tc);
> + if (ret)
> + goto err;
> +
Assuming this change will have a purpose further down in the series,
Reviewed-by: Laurent Pinchart <laurent.pinch...@ideasonboard.com>
On a side note you may want to remove the err label in
tc_stream_clock_calc(), or even inline the write to DP0_VIDMNGEN1 here
directly.
> value = VID_MN_GEN | DP_EN;
> if (tc->link.base.capabilities & DP_LINK_CAP_ENHANCED_FRAMING)
> value |= EF_EN;
--
Regards,
Laurent Pinchart
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
