Hi Andrey,
On 03/04/2019 14:34, Tomi Valkeinen wrote:
> On 02/04/2019 05:16, Andrey Smirnov wrote:
>
>> The early return above causes tc_get_display_props() to never be
>> called for eDP case, which in turn result in tc_mode_valid() returning
>> MODE_BAD for every mode it is given since it depends on tc->link.base
>> being initialized properly. I had to change this code to:
>>
>> if (tc->hpd_num < 0) {
>> if (!tc->panel)
>> return connector_status_unknown;
>>
>> conn = true;
>> } else {
>> tc_read(GPIOI, &val);
>>
>> conn = val & BIT(tc->hpd_num);
>> }
>>
>> to fix the problem.
>
> Ah, right. There's tc_get_display_props() in tc_bridge_enable() but
> that's of course too late (and maybe even not needed at all).
>
> What you suggest here looks fine to me, so I'll change my patch
> accordingly. Thanks!
With the change above, does the series work with your setup? Can I add
your tested-by? I'll send v3 series soon with the DT change suggested by
Rob and the above fix.
Tomi
--
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
