Add the display nodes containing information about the panel, DSI configuration and board specific pin configuration to the SDM845 MTP device tree file.
This patch depends on the following: https://patchwork.freedesktop.org/series/51909/ Changes in v4: - patch introduced in the series - move around added nodes to preserve alphabetical order (Doug Anderson) Changes in v5: - include board specific pin configuration (Doug Anderson) - remove display timing from the panel node Signed-off-by: Sandeep Panda <spa...@codeaurora.org> Signed-off-by: Jeykumar Sankaran <jsa...@codeaurora.org> Signed-off-by: Abhinav Kumar <abhin...@codeaurora.org> --- arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 118 ++++++++++++++++++++++++++++++++ 1 file changed, 118 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/sdm845-mtp.dts b/arch/arm64/boot/dts/qcom/sdm845-mtp.dts index d667eee..ee63783 100644 --- a/arch/arm64/boot/dts/qcom/sdm845-mtp.dts +++ b/arch/arm64/boot/dts/qcom/sdm845-mtp.dts @@ -7,6 +7,7 @@ /dts-v1/; +#include <dt-bindings/gpio/gpio.h> #include <dt-bindings/regulator/qcom,rpmh-regulator.h> #include "sdm845.dtsi" @@ -343,11 +344,98 @@ }; }; +&dsi0 { + status = "okay"; + qcom,dual-dsi-mode; + qcom,master-dsi; + qcom,sync-dual-dsi; + + vdda-supply = <&vdda_mipi_dsi0_1p2>; + + panel@0 { + compatible = "truly,nt35597-2K-display"; + reg = <0>; + + vdda-supply = <&vreg_l14a_1p88>; + vdispp-supply = <&lab_regulator>; + vdispn-supply = <&ibb_regulator>; + + pinctrl-names = "default"; + pinctrl-0 = <&disp_mode_sel &lcd_reset_n>; + + mode-gpios = <&tlmm 52 GPIO_ACTIVE_HIGH>; + reset-gpios = <&tlmm 6 GPIO_ACTIVE_LOW>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + port@0 { + reg = <0>; + panel0_in: endpoint { + remote-endpoint = <&dsi0_out>; + }; + }; + + port@1 { + reg = <1>; + panel1_in: endpoint { + remote-endpoint = <&dsi1_out>; + }; + }; + }; + }; + + ports { + port@1 { + endpoint { + remote-endpoint = <&panel0_in>; + data-lanes = <0 1 2 3>; + }; + }; + }; +}; + +&dsi0_phy { + status = "okay"; + vdds-supply = <&vdda_mipi_dsi0_pll>; +}; + +&dsi1 { + status = "okay"; + + qcom,dual-dsi-mode; + qcom,sync-dual-dsi; + + vdda-supply = <&vdda_mipi_dsi1_1p2>; + + ports { + port@1 { + endpoint { + remote-endpoint = <&panel1_in>; + data-lanes = <0 1 2 3>; + }; + }; + }; +}; + +&dsi1_phy { + status = "okay"; + vdds-supply = <&vdda_mipi_dsi1_pll>; +}; + &i2c10 { status = "okay"; clock-frequency = <400000>; }; +&mdss { + status = "okay"; +}; + +&mdss_mdp { + status = "okay"; +}; + &qupv3_id_1 { status = "okay"; }; @@ -444,3 +532,33 @@ bias-pull-up; }; }; + + /* PINCTRL - board-specific pinctrl */ + +&tlmm { + disp_mode_sel: disp-mode-sel { + pinmux { + function = "gpio"; + pins = "gpio52"; + }; + + pinconf { + pins = "gpio52"; + drive-strength = <8>; + bias-disable; + }; + }; + + lcd_reset_n: lcd-reset-n { + pinmux { + function = "gpio"; + pins = "gpio6"; + }; + + pinconf { + pins = "gpio6"; + drive-strength = <8>; + bias-disable; + }; + }; +}; -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel
