On Wed, Nov 07, 2018 at 07:10:38AM -0500, Brian Dodge wrote:
> The vendor-prefixes.txt file properly refers to ArcticSand
> as arctic but the driver bindings improperly abbreviated the
> prefix to arc. This was a mistake in the original patch
>
Are there any users and are they okay with this changing?
> Signed-off-by: Brian Dodge <bdodg...@gmail.com>
> ---
> .../bindings/leds/backlight/arcxcnn_bl.txt | 20
> ++++++++++----------
> 1 file changed, 10 insertions(+), 10 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
> b/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
> index 230abde..dcaa239 100644
> --- a/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
> +++ b/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
> @@ -1,8 +1,8 @@
> -Binding for ArcticSand arc2c0608 LED driver
> +Binding for ArcticSand arc family LED drivers
>
> Required properties:
> -- compatible: should be "arc,arc2c0608"
> -- reg: slave address
> +- compatible: "arctic,arc1c0608", "arctic,arc2c0608",
> "arctic,arc3c0845"
Format one per line please.
> +- reg: slave address
>
> Optional properties:
> - default-brightness: brightness value on boot, value from: 0-4095
> @@ -11,19 +11,19 @@ Optional properties:
> - led-sources: List of enabled channels from 0 to 5.
> See Documentation/devicetree/bindings/leds/common.txt
>
> -- arc,led-config-0: setting for register ILED_CONFIG_0
> -- arc,led-config-1: setting for register ILED_CONFIG_1
> -- arc,dim-freq: PWM mode frequence setting (bits [3:0] used)
> -- arc,comp-config: setting for register CONFIG_COMP
> -- arc,filter-config: setting for register FILTER_CONFIG
> -- arc,trim-config: setting for register IMAXTUNE
> +- arctic,led-config-0: setting for register ILED_CONFIG_0
> +- arctic,led-config-1: setting for register ILED_CONFIG_1
> +- arctic,dim-freq: PWM mode frequence setting (bits [3:0] used)
> +- arctic,comp-config: setting for register CONFIG_COMP
> +- arctic,filter-config: setting for register FILTER_CONFIG
> +- arctic,trim-config: setting for register IMAXTUNE
>
> Note: Optional properties not specified will default to values in IC EPROM
>
> Example:
>
> arc2c0608@30 {
> - compatible = "arc,arc2c0608";
> + compatible = "arctic,arc2c0608";
> reg = <0x30>;
> default-brightness = <500>;
> label = "lcd-backlight";
> --
> 2.7.4
>
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
