On Sat, 2017-06-03 at 11:57 -0700, Steve Longerbeam wrote:
> From: Marek Vasut <ma...@denx.de>
> 
> The description of the CSI_SEL bit in the i.MX6 reference manual is
> incorrect. It states "This bit defines which CSI is the input to the
> IC. This bit is effective only if IC_INPUT is bit cleared".
> 
> From experiment it was found this is in fact not correct. The CSI_SEL
> bit selects which CSI is input to _both_ the VDIC _and_ the IC. If the
> IC_INPUT bit is set so that the IC is receiving from the VDIC, the IC
> ignores the CSI_SEL bit, but CSI_SEL still selects which CSI the VDIC
> receives from in that case.
> 
> Signed-off-by: Marek Vasut <ma...@denx.de>
> Signed-off-by: Steve Longerbeam <steve_longerb...@mentor.com>
> ---
>  drivers/gpu/ipu-v3/ipu-common.c | 15 ++++++++-------
>  1 file changed, 8 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/gpu/ipu-v3/ipu-common.c b/drivers/gpu/ipu-v3/ipu-common.c
> index 16d5568..2fb5f43 100644
> --- a/drivers/gpu/ipu-v3/ipu-common.c
> +++ b/drivers/gpu/ipu-v3/ipu-common.c
> @@ -725,15 +725,16 @@ void ipu_set_ic_src_mux(struct ipu_soc *ipu, int 
> csi_id, bool vdi)
>       spin_lock_irqsave(&ipu->lock, flags);
>  
>       val = ipu_cm_read(ipu, IPU_CONF);
> -     if (vdi) {
> +     if (vdi)
>               val |= IPU_CONF_IC_INPUT;
> -     } else {
> +     else
>               val &= ~IPU_CONF_IC_INPUT;
> -             if (csi_id == 1)
> -                     val |= IPU_CONF_CSI_SEL;
> -             else
> -                     val &= ~IPU_CONF_CSI_SEL;
> -     }
> +
> +     if (csi_id == 1)
> +             val |= IPU_CONF_CSI_SEL;
> +     else
> +             val &= ~IPU_CONF_CSI_SEL;
> +
>       ipu_cm_write(ipu, val, IPU_CONF);
>  
>       spin_unlock_irqrestore(&ipu->lock, flags);

Applied, thanks.

regards
Philipp

_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel

Reply via email to