DECON command mode can use hardware trigger where transmission
is triggered automatically, or software trigger - where TE interrupt
handler should trigger transmission.
DECON will use software trigger if TE interrupt is specified.
Signed-off-by: Andrzej Hajda <a.ha...@samsung.com>
---
Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git
a/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt
b/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt
index ba6be99..549c538 100644
--- a/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt
+++ b/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt
@@ -10,7 +10,8 @@ Required properties:
- reg: physical base address and length of the DECON registers set.
- interrupt-names: should contain the interrupt names depending on mode of
work:
video mode: "vsync",
- command mode: "lcd_sys".
+ command mode: "lcd_sys",
+ command mode with software trigger: "lcd_sys", "te".
- interrupts or interrupts-extended: list of interrupt specifiers corresponding
to names privided in interrupt-names, as described in
interrupt-controller/interrupts.txt
--
2.7.4
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
