Certain revisions of the vbios on DCE3.2 cards have a bug
in the transmitter control table which prevents duallink from
being enabled properly on some cards. The action switch statement
jumps to the wrong offset for the OUTPUT_ENABLE action. The fix
is to use the ENABLE action rather than the OUTPUT_ENABLE action
on the affected cards. In fixed version of the vbios, both
actions jump to the same offset, so the change should be safe.
Signed-off-by: Alex Deucher <alexdeuc...@gmail.com>
Cc: sta...@kernel.org
---
drivers/gpu/drm/radeon/radeon_encoders.c | 6 +++++-
1 files changed, 5 insertions(+), 1 deletions(-)
diff --git a/drivers/gpu/drm/radeon/radeon_encoders.c
b/drivers/gpu/drm/radeon/radeon_encoders.c
index 175a1e3..b293487 100644
--- a/drivers/gpu/drm/radeon/radeon_encoders.c
+++ b/drivers/gpu/drm/radeon/radeon_encoders.c
@@ -1432,7 +1432,11 @@ radeon_atom_encoder_dpms(struct drm_encoder *encoder,
int mode)
if (is_dig) {
switch (mode) {
case DRM_MODE_DPMS_ON:
- atombios_dig_transmitter_setup(encoder,
ATOM_TRANSMITTER_ACTION_ENABLE_OUTPUT, 0, 0);
+ /* some early dce3.2 boards have a bug in their
transmitter control table */
+ if ((rdev->family == CHIP_RV710) || (rdev->family ==
CHIP_RV730))
+ atombios_dig_transmitter_setup(encoder,
ATOM_TRANSMITTER_ACTION_ENABLE, 0, 0);
+ else
+ atombios_dig_transmitter_setup(encoder,
ATOM_TRANSMITTER_ACTION_ENABLE_OUTPUT, 0, 0);
if (atombios_get_encoder_mode(encoder) ==
ATOM_ENCODER_MODE_DP) {
struct drm_connector *connector =
radeon_get_connector_for_encoder(encoder);
--
1.7.1.1
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/dri-devel
