On Sun, 3 Feb 2019 3:42 am Yannis Milios <[email protected] wrote:
> You have to specify which storage pool to use for the resource, otherwise > it will default to 'DfltStorPool', which does not exist. So that would be > something like this... > > $ linstor resource create pve3 vm-400-disk-1 --storage-pool <storage_pool> > > > It might be also wise to check and compare the settings of the resource on > an existing node, and then add any missing entries for the resource on the > new node. For example .. > > $ linstor rd lp pve2 vm-400-disk-1 #This will show the settings for >> vm-400-disk-1 on node pve2 > > > >> $ linstor rd lp pve3 vm-400-disk-1 #This will show the settings for >> vm-400-disk-1 on node pve3 > > > Compare settings, and if needed add any missing entries. This is only > needed for the existing resources. > Are you saying this needs to be done for every single resource potentially hundreds of vm's with multiple disks attached? This sounds like a huge pita. Any new resources (VMs) you create on Proxmox will be automatically created > with the correct settings (assuming that you have increased redundancy from > 2 to 3 in /etc/pve/storage.cfg). > > P.S > I strongly recommend using 'linstor interactive' mode to familiarise > yourself to linstor command line parameters. > > Yannis > _______________________________________________ > drbd-user mailing list > [email protected] > http://lists.linbit.com/mailman/listinfo/drbd-user >
_______________________________________________ drbd-user mailing list [email protected] http://lists.linbit.com/mailman/listinfo/drbd-user
