Check the logs for the reason the node went to diskless.
You don’t say the state of the nodes before the sync nor the method of requesting the full sync. If these are the same nodes as your recent message (DRBD 8.0.13-HA 2.1.3 sync after physical move), something interesting changed; either CLI commands or log file messages. Both disks were attached in those status displays. If these are different nodes, then we are still in the dark. Dan From: [email protected] [mailto:[email protected]] On Behalf Of Bruce Wolfe Sent: Saturday, July 30, 2011 7:47 PM To: [email protected] Subject: [DRBD-user] Secondary node is Diskless Hi! After a full sync, Serv2 (Secondary) is now showing ds:Diskless/UpToDate. Is there something wrong with Serv2's hard drive? What would be the procedure for checking this out? I was under the impression that it should show UpToDate, too. Thanks in advance. Bruce M. Wolfe, M.S.W., CIO Description: Image removed by sender. 24 Belvedere St. San Rafael, CA 94901 415/456.5692 x213 main 415/257.2493 office 415/456.0491 fax KI6BSL ham "Power is not a means, it is an end. One does not establish a dictatorship in order to safeguard a revolution; one makes the revolution in order to establish the dictatorship." - George Orwell _____
<<~WRD000.jpg>>
_______________________________________________ drbd-user mailing list [email protected] http://lists.linbit.com/mailman/listinfo/drbd-user
