Iam running managed failovers and after 7 failovers, i have dmesg print as
In a managed failovers, drbd partition is unmounted first and then "drbdadm
Secondary all" is invoked.
Network is not touched until drbd transition to secondary is done.
Any help to avoid this in managed failovers is appreciated.
drbd0: drbd_sync_handshake:
drbd0: self B3846B4B8BDF8064:B3846B4B8BDF8065:E3596DA0539760BC:0ECF8BD380756C2D
drbd0: peer B3846B4B8BDF8065:B3846B4B8BDF8065:E3596DA0539760BD:0ECF8BD380756C2D
drbd0: uuid_compare()=0 by rule 4
drbd0: No resync, but 278 bits in bitmap!
*rule_nr = 4;
if (self == peer) { /* Common power [off|failure] */
int rct, dc; /* roles at crash time */
rct = (test_bit(CRASHED_PRIMARY, &mdev->flags) ? 1 : 0) +
(mdev->p_uuid[UUID_FLAGS] & 2);
/* lowest bit is set when we were primary,
* next bit (weight 2) is set when peer was primary */
MTRACE(TraceTypeUuid, TraceLvlMetrics, DUMPI(rct); );
switch (rct) {
case 0: /* !self_pri && !peer_pri */ return 0;
case 1: /* self_pri && !peer_pri */ return 1;
case 2: /* !self_pri && peer_pri */ return -1;
case 3: /* self_pri && peer_pri */
dc = test_bit(DISCARD_CONCURRENT, &mdev->flags);
MTRACE(TraceTypeUuid, TraceLvlMetrics, DUMPI(dc); );
return dc ? -1 : 1;
}
}
Thanks and Regards
Lak
From: [email protected]
To: [email protected]
Date: Wed, 15 Sep 2010 04:35:03 +0000
Subject: [DRBD-user] What is the recommended recovery action/config for rules 5
and 6
DRBD version: 8.0.16
We are forced to use this version of drbd, because of the older kernel version.
Every 10 failovers i run into either rule_nr = 5 or rule_nr = 6.
Its been over a month since we are trying to figure out the rootcause for this,
but in vain.
We have terminated all apps accessing drbd partition before calling drbdadm
secondary all and umount drbd partition.
With this change we are able to run about 30 failovers successfully. But we
have hit rule_nr 5 after this.
Can any one of you help us with recommended recovery action / config change for
rules 5 and 6.
*rule_nr = 5;
peer = mdev->p_uuid[Bitmap] & ~((u64)1);
if (self == peer)
return -1;
*rule_nr = 6;
for (i = History_start; i <= History_end; i++) {
peer = mdev->p_uuid[i] & ~((u64)1);
if (self == peer)
return -2;
}
Thanks and Regards
Lak.
_______________________________________________ drbd-user mailing list
[email protected] http://lists.linbit.com/mailman/listinfo/drbd-user
_______________________________________________
drbd-user mailing list
[email protected]
http://lists.linbit.com/mailman/listinfo/drbd-user
