Why do I need to download Dovecot-2.0 to enable sieve? From looking at
the dovecot website and other howto's Sieve will work with Dovecot-1.*.
On 4/12/2011 7:21 PM, 邓卫华 wrote:
you have to download dovecot-2.0-pigeonhole-0.2.2 and install it to
enable sieve in dovecot.
On Wed, 13 Apr 2011 00:34:11 +0300, Timo
Sirainen wrote:
Then it sounds like the Dovecot version you're
running hasn't been patched with managesieve support. I don't actually
see you mention how you upgraded, from source or from some binary
package (and in what OS/distro).
Note that with v1.x if you install
Dovecot + Sieve you do get both of them, but it doesn't automatically
mean that Managesieve is installed. You need to patch Dovecot for that
(sieve is not managesieve!)
On 13.4.2011, at 0.17, Jay Welch
wrote:
It is managesieve. protocol managesieve { # Specify an
alternative address:port the daemon must listen on # (default: *:2000)
listen = localhost:2000 managesieve_logout_format = bytes ( in=%i :
out=%o ) } I just did a cut and paste into the conf file. On 4/12/2011
2:14 PM, Timo Sirainen wrote:
On 13.4.2011, at 0.09, Jay Welch
wrote:
Starting Dovecot Imap: Error: Error in configuration
file /etc/dovecot.conf line 676: Unknown protocol name (section changed
in /etc/dovecot.conf at line 674)
Unfortunately it doesn't say here
what the name is.
The protocol on line 674 is the Manageseive
protocol. Not sure where I am going wrong with this? Any help is much
appreciated.
Is it Managesieve or managesieve? The case matters
here..
-- This message has been scanned for viruses and dangerous
content by MailScanner, and is believed to be clean.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
