Hi Ralph
On 30/07/2019 12:41, Ralph Corderoy wrote:
Hi Tim,
I'm compiling a summary of your results.
# avahi-browse -at
+ wlp1s0 IPv6 Brother HL-5270DN series @ golux Internet Printer local
...
As above, AP0 shows only IPv6 entries. I have IPv6 disabled on that AP
(a Draytek 2862), following our discussions where you suggested I try
that. On AP1 and AP2 I get IPv4 entries too.
If I disable IPv6 on AP0 (which causes it to reboot),
Am I reading that correctly? Despite IPv6 being disabled on AP0, when
connected to it avahi-browse shows IPv6 results? It then goes on to say
IPv6 is then altered to be disabled on that AP, but it already was?
Or are some 4/6 en/dis mixed up? :-)
They are a bit mixed up. Basically, it's a toggle setting and toggling the IPv6
resets the router and I get IPv4 entries in the avahi-browse response (IPv6
enabled or disabled). Switching to one of the other AP's, and back again, and I
just get IPv6 entries appearing, whether IPv6 is enabled or disabled on AP0
(which is definitely strange).
I did find
https://wiki.debian.org/DissectingandDebuggingtheCUPSPrintingSystem#The_CUPS_Error_Log
that describes how to get more information out of CUPS.
I'll take a look.
Cheers
Tim
--
Next meeting: BEC, Bournemouth, Tuesday, 2019-08-06 20:00
Check to whom you are replying
Meetings, mailing list, IRC, ... http://dorset.lug.org.uk/
New thread, don't hijack: mailto:dorset@mailman.lug.org.uk
