Am 2020-06-12 20:25, schrieb richard lucassen:
Try to add "nofail" or "noauto":
nofail was a good hint. Now the system boots, but the usb disk is still
not mounted. "mount -a" mounts it without errors after boot.
I see no errors in /var/log/boot and dmesg.
The only messages concerning this drive:
[ 4.153932] scsi 0:0:0:0: Direct-Access WD Elements 25A3
1021 PQ: 0 ANSI: 6
[ 4.159536] sd 0:0:0:0: [sda] Spinning up disk...
[ 4.161466] sd 0:0:0:0: Attached scsi generic sg0 type 0
[ 22.522458] sd 0:0:0:0: [sda] Very big device. Trying to use READ
CAPACITY(16).
[ 22.524863] sd 0:0:0:0: [sda] 19532808192 512-byte logical blocks:
(10.0 TB/9.09 TiB)
[ 22.532067] sd 0:0:0:0: [sda] 4096-byte physical blocks
[ 22.538598] sd 0:0:0:0: [sda] Write Protect is off
[ 22.541988] sd 0:0:0:0: [sda] Mode Sense: 47 00 10 08
[ 22.542724] sd 0:0:0:0: [sda] No Caching mode page found
[ 22.547320] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 22.554350] sd 0:0:0:0: [sda] Very big device. Trying to use READ
CAPACITY(16).
[ 22.983388] sda: sda1
[ 22.984576] sd 0:0:0:0: [sda] Very big device. Trying to use READ
CAPACITY(16).
[ 22.989231] sd 0:0:0:0: [sda] Attached SCSI disk
_______________________________________________
Dng mailing list
Dng@lists.dyne.org
https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
