* Thomas Glanzmann <tho...@glanzmann.de> [230222 14:15]: > Hello, > I have Debian bullseye connected to an AFF A220 NetApp iSCSI target with > ALUA enabled. I see two paths, however multipathd doesn't seem to > configure a multipath device for the two paths. Find the output of the > following commands here:
> multipath -T > find_multipaths "strict" Per multipath.conf(5): | strict Both multipath and multipathd treat only such devices as multipath devices which have been | part of a multipath map previously, and which are therefore listed in the wwids_file. | Users can manually set up multipath maps using the multipathd add map command. Once set up | manually, the map is remembered in the wwids file and will be set up automatically in the | future. I would guess your wwids/bindings files are empty, and thus you need to follow the advice in the manpage: use multipathd add map, or maybe multipath -a. If you decide to change find_multipaths, I would suggest verifying that your resulting setup works across reboots, etc. By the way, I think the current recommendation for modern NetApp platforms is `prio "alua"`, not `ontap`. Would be good if NetApp would confirm this somehow/somewhere. Best, Chris -- dm-devel mailing list dm-devel@redhat.com https://listman.redhat.com/mailman/listinfo/dm-devel
