Hi. I'm trying to implement the VTEP Emulator from
https://github.com/openvswitch/ovs/blob/master/vtep/README.ovs-vtep.md
I've built OVS from source on Centos7.

When I run 'ovs-vsctl add-port br0 p0', I get an error about the unexisting
device, so, to avoid it I run 'brctl addbr p0' before.

When I want to bind a logical switch to any of my bridge ports, I get an
error. I've even added a spare physical port to br0, just to try, but this
fails too.
[root@ovs11 ovs]# ovs-vsctl show
e27227fb-c93b-4ab6-ac39-574374a8211b
    Bridge "br0"
        Port "eth2"
            Interface "eth2"
        Port "p1"
            Interface "p1"
        Port "br0"
            Interface "br0"
                type: internal
        Port "p0"
            Interface "p0"
[root@ovs11 ovs]# vtep-ctl bind-ls br0 eth2 0 ls0
vtep-ctl: no port named eth2
[root@ovs11 ovs]# vtep-ctl bind-ls br0 p0 0 ls0
vtep-ctl: no port named p0

While I have no problems in logs or running commands in verbose(-v) mode.
May I have a more repeatable manual to try NVC? Thanks in advance.

-- 
Regards, Mikhail Bagrov
DevOps at Kuberdock
_______________________________________________
discuss mailing list
discuss@openvswitch.org
http://openvswitch.org/mailman/listinfo/discuss

Reply via email to