I see a OFPT_PORT_STATUS message when a port goes down, e.g. when I run "ifconfig eth0 down".
On Tue, Nov 03, 2015 at 11:35:49AM +0530, tech_kals Kals wrote: > Hi all, > > can someone please have a look at my query? Should I explain in depth ? > am really surprised when i dont get any answer to this question? > > > On Mon, Nov 2, 2015 at 9:24 AM, tech_kals Kals <tech.k...@gmail.com> wrote: > > > Hi, > > > > Could someone please clarify my doubt? I am really stuck on this issue? > > > > Thanks, > > Kals. > > > > On Sat, Oct 31, 2015 at 9:55 AM, tech_kals Kals <tech.k...@gmail.com> > > wrote: > > > >> could someone have a look at this qury ? > >> > >> Hi Ben, > >> Could you please clarify my doubt ? > >> > >> On Fri, Oct 30, 2015 at 1:29 PM, tech_kals Kals <tech.k...@gmail.com> > >> wrote: > >> > >>> Hi folks, > >>> > >>> As per openflow specification, if port config bits are changed by the > >>> switch through another administrative interface, the switch sends an > >>> OFPT_PORT_STATUS message to notify the controller of the change. Does OVS > >>> supports this functionality? > >>> > >>> If OVS doesn't support this then how a switch would inform the > >>> controller when a port is configured to admin down through by some other > >>> administrative interface like CLI. > >>> > >>> Can someone quickly clarify my doubt ? > >>> > >>> Thanks, > >>> ~Kals~ > >>> > >>> > >>> > >>> > >>> > >>> > >>> > >> > > _______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
