eth2 is not the interface to a VM - it is the uplink to the physical network. A VM interface is actually connected to a particular virtual machine.
There are several tutorials about setting up OVS available online. I would recommend that you follow one and then try to make modifications from there. On Tue, Jul 7, 2015 at 9:17 PM, Abhishek Verma <[email protected]> wrote: > Hi, > > I dont understand. > > eth2 is my VM port. And i have added that to the OVS bridge "mybridge" > > Am i missing something? > > Thanks, Abhishek > > On Wed, Jul 8, 2015 at 8:50 AM, Jesse Gross <[email protected]> wrote: >> >> On Tue, Jul 7, 2015 at 8:11 PM, Abhishek Verma >> <[email protected]> wrote: >> > Hi, >> > >> > I want to test OVS between two virtual machines hosted over the same >> > host. I >> > created an OVS bridge where i added the NIC that connects the two VMs >> > and >> > used ifconfig to assign an IP address to the bridge port. >> > >> > With this i am able to ping the two VMs. >> > >> > root@VirtualBox:/home/akabra# ovs-vsctl show >> > e71e7608-7bfe-4293-ac5a-8705355ba16e >> > >> > Bridge mybridge >> > Port mybridge >> > Interface mybridge >> > type: internal >> > Port "eth2" >> > Interface "eth2" >> > root@VirtualBox:/home/akabra# >> > >> > root@VirtualBox:/home/akabra# ifconfig >> > eth2 Link encap:Ethernet HWaddr 08:00:27:7b:2d:b2 >> > inet6 addr: fe80::a00:27ff:fe7b:2db2/64 Scope:Link >> > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 >> > RX packets:1074400 errors:0 dropped:0 overruns:0 frame:0 >> > TX packets:3290 errors:0 dropped:0 overruns:0 carrier:0 >> > collisions:0 txqueuelen:1000 >> > RX bytes:1003962152 (1.0 GB) TX bytes:363441 (363.4 KB) >> > >> > mybridge Link encap:Ethernet HWaddr 08:00:27:7b:2d:b2 >> > inet addr:2.2.2.2 Bcast:2.2.2.255 Mask:255.255.255.0 >> > inet6 addr: fe80::c8f8:7cff:fe8a:5b4a/64 Scope:Link >> > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 >> > RX packets:36387 errors:0 dropped:0 overruns:0 frame:0 >> > TX packets:3160 errors:0 dropped:0 overruns:0 carrier:0 >> > collisions:0 txqueuelen:0 >> > RX bytes:8220698 (8.2 MB) TX bytes:340708 (340.7 KB) >> > >> > I did exactly the same on the other VM and am able to ping between the >> > two >> > VMs. >> >> You need to add the VM ports to OVS. Currently only traffic between >> eth2 and the hypervisor host is going through OVS. > > _______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
