Thank, Ben. Can you please elaborate more about the optimization "should only affect cases where a MAC would otherwise quickly bounce back and forth between a number of learned ports." I reproduced it with a simple setup which has only three switches forming a triangle (VLAN set up to avoid loop), but the problem still exists.
Is it possible for me to disable this optimization temporarily? If so, will the bouncing issue be solved? Thanks! Cheng On Tue, Mar 3, 2015 at 3:03 PM, Ben Pfaff <b...@nicira.com> wrote: > On Tue, Mar 03, 2015 at 12:25:20PM -0600, Cheng Jin wrote: > > I have a problem with updating OVS' MAC learning table, when it is in the > > 'standalone' mode running like a legacy Ethernet bridge. > > > > The switch has an entry to a destination, including the destination MAC > > (say, 00:00:00:00:00:01), an output port (say, 1), VLAN, and Age. > However, > > the switch sometimes does not update the entry, when it receives a packet > > from the same destination (still 00:00:00:00:00:01) but from a new > incoming > > port (say, 2). Does someone know what may cause this issue? > > > > The MAC learning table is supposed to be updated once receiving a packet. > > Does OVS do some optimization to process the packets so that the learning > > table may not get updated when the packet rate is high? > > The optimization that OVS does should only affect cases where a MAC > would otherwise quickly bounce back and forth between a number of > learned ports. > > Is there anything unusual in your setup? Can you reproduce this with > a simple setup? > -- Cheng Jin Ph.D Candidate Department of Computer Science and Engineering University of Minnesota
_______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
