> On Jul 9, 2014, at 1:13 AM, "Pavel V. Kaygorodov" <pa...@inasan.ru> wrote:
>
> Hi!
>
> Thank you for response, I have already found a eth0->eth1 mistake, but this
> was not enough.
> The complete solution, after a number of experiments is:
>
> # The order is important: eth1 must be after br0!
> auto br0 eth1 br0:1
>
> allow-ovs br0
> iface br0 inet static
> address 192.168.111.1
> netmask 255.255.255.0
> ovs_type OVSBridge
> ovs_ports eth1
> # Starting up openvswitch daemon if it was not started already
> pre-up /etc/init.d/openvswitch-switch start
>
> allow-br0 eth1
> iface eth1 inet manual
> ovs_bridge br0
> ovs_type OVSPort
> pre-up ifconfig $IFACE up
> post-down ifconfig $IFACE down
>
> allow-br0 br0:1
> iface br0:1 inet static
> address 192.168.111.2
> netmask 255.255.255.0
>
> ##################################
>
> I think, this tricks with "pre-up /etc/init.d/openvswitch-switch start" and
> "auto" order must be documented.
Did you read my first email and try removing things from auto?
>
> Pavel.
>
>
>>> On Jul 8, 2014, at 3:08 AM, "Pavel V. Kaygorodov" <pa...@inasan.ru> wrote:
>>>
>>> Hi!
>>>
>>> I have installed openvswitch-2.3.90 on Debian wheezy, and changed
>>> /etc/network/interfaces:
>>>
>>> auto lo eth1 br0
>>> iface lo inet loopback
>>>
>>> # The primary network interface
>>> allow-hotplug eth0
>>> iface eth0 inet dhcp
>>>
>>> allow-ovs br0
>>> iface br0 inet static
>>> address 192.168.111.1
>>> netmask 255.255.255.0
>>> ovs_type OVSBridge
>>> ovs_ports eth1
>>>
>>> allow-br0 eth1
>>> iface eth0 inet manual
>> You probably want eth1 above.
>>> ovs_bridge br0
>>> ovs_type OVSPort
>>> pre-up ifconfig $IFACE up
>>> post-down ifconfig $IFACE down
>>>
>>> after reboot I see br0 interface with proper IP address, but without eth1
>>> port added:
>>>
>>> # ovs-vsctl show
>>> 3ec07e03-5a5a-44ec-8543-3a9bc380bfdb
>>> Bridge "br0"
>>> Port "br0"
>>> Interface "br0"
>>> type: internal
>>> ovs_version: "2.3.90"
>>>
>>> I think this is because openvswitch-switch isn't started before network
>>> interface configuration stage, I see following errors on boot screen:
>>>
>>> <PastedGraphic-1.png>
>>>
>>> How can I fix this?
>>>
>>> Pavel.
>>>
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> discuss mailing list
>>> discuss@openvswitch.org
>>> http://openvswitch.org/mailman/listinfo/discuss
>
_______________________________________________
discuss mailing list
discuss@openvswitch.org
http://openvswitch.org/mailman/listinfo/discuss
