On Fri, May 10, 2013 at 02:00:47PM +0530, love you wrote: > First issue faced : > 1) I have created 2 bridges of different subnet br0 and br1 on the same > machine > 2) Two Virtual machines acting as two controllers vm1 and vm2. > 3) Now br0 is added to VM1 and br1 is added to VM2 (br0 and VM1 are of > same subnet and same applies to br1 and VM1)
Your description is unclear. What does it mean to add a bridge to a VM? > 4) Now when I add flow entry on br1 through the controller the flow > entry shows that is added to controller on VM1 but on switch side the flow > entry is added to br0 when I do dump-flows br0. Your description is unclear. What does it mean to add a flow entry to a controller? The best thing you could do here is to give a succinct but complete description of how we can see the same problem. > And the second issue faced is : > 1) I have created 2 bridges of different subnet br0 and br1 on the same > machine > 2) 1 Virtual machine acting as a NOX controller have two interfaces > eth0 and eth1 of different subnets. > 3) Now br0 is added to eth0 and br1 is added to eth1 (br0 and eth0 > are of same subnet and same applies to br1 and eth0) What does it mean to add a bridge to an interface? > 4) When I start the NOX controller both the controllers don?t come in > ACTIVE state. The state of the controllers toggle between BACKOFF to ACTIVE It sounds like the controller is dropping the connections from the switches. _______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
