Thank you for the correction. I sent out a patch to fix the manpage.
On Thu, Jul 12, 2012 at 12:58:02PM +0800, Kris zhang wrote: > Thanks, Ben. please see the manual page: > http://openvswitch.org/cgi-bin/ovsman.cgi?page=utilities%2Fovs-vsctl.8 > > it says use : > > * > remove Bridge br0 mirrors mymirror* > > BTW, the command you give me is working, but a little change: > > ovs-vsctl -- --id=@rec get mirror mymirror \ > > -- remove Bridge br0 mirrors @rec > > Thanks again, > > Kris > > > On Thu, Jul 12, 2012 at 11:56 AM, Ben Pfaff <b...@nicira.com> wrote: > > > On Thu, Jul 12, 2012 at 11:39:24AM +0800, Kris zhang wrote: > > > But when i use the following the command to remove the mirror: > > > > > > * > > > remove Bridge br0 mirrors mymirror* > > > > > > * > > > * > > > > > > I found i can not remove it. so i tried: ovs-vsctl remove Bridge br0 > > > mirrors mymirror. But it still doesn't work. > > > > It's true. Only UUIDs are accepted here; names are not. > > > > > Next i use the ovs-vsctl list > > > bridge to check the column mirrors, i found its value is a uuid. so i > > tried: > > > > > > *ovs-vsctl remove Bridge br0 mirrors <mymirror_uuid>* > > > > > > > > > the above command is ok. > > > > Yes. > > > > > Is this is known issue? if not, please also update the manual pages. > > > > Does the manual page say you can use that syntax? I do not think that > > it does. > > > > You can use this command instead of the one that you tried: > > > > ovs-vsctl -- --id=@rec get mirrors mymirror \ > > -- remove Bridge br0 mirrors @rec > > > > or if you just have one mirror: > > > > ovs-vsctl clear Bridge br0 mirrors > > _______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
