Hey,
I was trying to run the NOX controller pyswitch script and my mini net setup on
a VM could communicate the same script. However, my OVS couldn't connect to it.
I did the following:
$./nox_core –v –i ptcp: pyswitch
$sudo ovs-vsctl set-controller ovs-br0 ptcp:
$sudo ovs-vsctl show
Bridge "ovsbr0"
Controller "ptcp:"
Port "ovsbr0"
Interface "ovsbr0"
type: internal
Port "vnet0"
Interface "vnet0"
Port "vnet1"
Interface "vnet1"
vnet0 and vnet1 are tap interfaces of VMs. Vms corresponding to vnet0 & vnet1
can ping each other but there's no activity in now script (I.e. Its not
connected)
Is there a mistake in what I'm doing? Is there any way to debug or find out
where is the problem in the setup?
Regards,
Neha Jatav
_______________________________________________
discuss mailing list
discuss@openvswitch.org
http://openvswitch.org/mailman/listinfo/discuss
