On Thu, Oct 13, 2011 at 03:42:01PM +0100, Mike Bursell wrote: > I've also done some further looking around, and it turns out that > official site (http://lartc.org/) suggests that IPv6 is not > supported for rate limiting, the site is very out of date, and it > should, in fact, be possible (see > http://tcn.hypert.net/tcmanual.pdf, for example). I'm guessing that > adding a second command, along the lines of > > #define POLICE_CONFIG_CMD_IP6 "/sbin/tc filter add dev %s parent ffff: > protocol ip6 prio 51 u32 match ip6 src 00::00/0 police rate %dkbit burst %dk > mtu 65535 drop flowid :1" > > ...might work, as long as both were applied (note that I've changed > the priority). Has anyone tried this, or are there other missing > pieces, such as how the packets are marked, that are likely to cause > problems? I'm willing to accept that there's much deeper work to be > done - I've only just started scratching the surface this afternoon, > and am very far from being a tc guru.
I don't know, but if you test it and it turns out to be effective, please let us know and we'll toss it in for the next version. _______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
